IMUX Card | Inverse Multiplexer (IMUX) Card Settings |
Table 7-5. The HSU Card Dial Screen Settings and Options
Parameter |
|
| User Options | Default | |
|
|
| |||
PRIMARY # | up to 10 numeric characters | 0000000000 | |||
HUNT GROUP # | up to10 numeric characters | 0000000000 | |||
AUTO ANSWER | yes | no |
|
| yes |
ANSWER TIMEOUT |
|
|
| 01 | |
DIAL TRIGGER | off | dtr | rs366 | v.25b | off |
|
|
|
|
|
|
ESCAPE CHAR | * # | 5 | 6 7 | 9 0 00 | * |
IMUX PRIMARY # | up to 10 numeric characters | 0000000000 | |||
IMUX HUNT # | up to 10 numeric characters | 0000000000 | |||
|
|
| |||
IMUX ADD # | up to 10 numeric characters | 0000000000 | |||
CURRENT PROFILE | none | loaded |
| none | |
PRIMARY #
The Primary Number is the main phone number used to route incoming
HUNT GROUP #
The Hunt Group number is an optional number that makes the port of this HSU part of a hunt group. The hunt group number is the same for all HSU ports in the hunt group. The system will route any incoming (non IMUX) call placed to the hunt group number to the first available HSU port in the group. A hunt group number must be within the range of numbers assigned by the carrier controlling the ISDN switch.
AUTO ANSWER
The Auto Answer feature allows the HSU port to automatically answer an incoming call for either the primary number or the hunt group number. A value of yes means the equipment will always accept the incoming call for a port that is not busy. A value of no means the HSU will not answer the call until the attached DTE responds with DTR high. RS530 ports will respond to auto answer with the Ring Indicator lead, V.35 ports must be set to auto answer for this version of the software.
ANSWER TIMEOUT
If the user chooses no for Auto Answer (above), the Answer Timeout parameter tells the system how long to wait for the DTE to raise DTR after the call has been sent to the DTE. This parameter is measured in seconds, and the valid choices are
Server Cards |
