Zhone Technologies 900, 800, 600 manual Typical Frame Relay Endpoints Screen

FRS Card ACS-FRS Card User Screens and Settings

2.3.2Frame Relay Endpoints Screen

You can have up to four frame relay endpoints (two for the actual endpoints of the PVC and two that can act as backup should the primary link fail). All frame relay endpoints are inventoried on the Frame Relay Endpoints Screen, and all endpoints must be defined from this screen before the user can provision the circuit.

Figure 2-3shows a typical Frame Relay Endpoints Screen, which can be viewed by pressing “e” (Endp) in the ACS-FRS Card Main Screen. Table 2-3lists the actions you can perform from the bottom line of this screen.

Figure 2-3.Typical Frame Relay Endpoints Screen

In Figure 2-3above illustrates the frame relay endpoint screen for two voice circuits terminated on port 01, and 02 transported over port “C1” via the HSU to the remote device. Figure 2-3also shows the three IP endpoints defined on C1 towards the remote device, and on C2 towards the IPR.

Server Cards 2-9