Woods Equipment 1012606 manual Backhoe 3-POINT Mount Installation, Tractor Preparation

BACKHOE 3-POINT MOUNT INSTALLATION

TRACTOR PREPARATION

NOTE: For installing this 3-point mounting kit, refer- ence to right, left, forward and rearward directions are determined from the operator’s position in the back- hoe seat.

NOTE: Leave all hardware loose until mounting kit has been fit up.

1.Refer to the WOODS BH90-X Backhoe Opera- tor’s Manual for backhoe assembly instructions.

2.Remove the tractor top link and top link storage bracket, if equipped.

* Operator’s seat must be located in the lowest and most forward position to obtain 40" minimum radius.

Figure 1. Seat Clearance

Attach Rear Brackets to Backhoe

1.Attach rear brackets (4 & 5) to main frame using bolts (6), hardened flat washers (16), and hex nuts (8) as shown in Figure 2.

2.Torque hardware to 297 lbs-ft.

4.37682 Right mount bracket

5.37683 Left mount bracket

6.13759 3/4 NC x 2-1/4 HHCS GR5

8.1450 3/4 NC Hex nut

16.57798 3/4 Hardened flat washer

Figure 2. Rear Bracket Installation

MAN0549 (6/30/2006) Installation 5