Xantech URC-2 installation instructions Specifications

Page 12

SPECIFICATIONS

Memory: 32 kbytes SRAM (super cap. backed)

IR Carrier Frequency: 31.25 kHz to 71.50 kHz

Range:Up to 70’ (Depends on controlled equipment and local conditions)

Number of Keys: 48 (8 Source, 40 Function)

Learning System: Direct Learning or by PC with DD4 Software (optional) (Similar to Smart Pad3)

Programming Functions: Sequencing, Delays, Step Editing (with Insert and Delete)

Sequence (macro) Capability: Commands per key limited only by memory

COM Port: 3-Pin, RS232 Signal Compatible

Cloning: Via 3-Pin COM Port

Sleep Mode: Begins 6 seconds after inactivity for Normal Operation (adjustable with DD4) Begins 30 seconds after inactivity when in Program Modes

Wake up: Activates with motion, a key press, or COM Port Connection

Lighted Panel Turn ON/OFF Time (with simultaneous press of VOL keys): 5 seconds

Power Source: 4 “AAA” Batteries (Alkaline recommended)

Dimensions: 7-3/4” x 2-3/8” x 1-1/16" (196 mm x 60 mm x 27 mm)

Weight: 6.6 oz. (.93 kg)

5-12-00

12

URC-2

Image 12
Contents Programmable Remote Controller Introduction Feature SummaryKeypad Descriptions Following are descriptions for the various keys and LEDsInstalling Batteries Teaching Single IR CommandsErrror has occurred and the command has not been learned When this happens, simply repeat , but this time varyDeleting Commands Press the key you wish to deleteProgramming Delays When finished with the sequence, exit Sequence Mode per FigDelay times entered are now stored as part of the sequence Sending IR CommandsDeleting a Command From a Sequence Inserting a CommandExceeding Memory Limits Sequence EditingInserting a Delay RestoreClearing all Memory Bear in mind that all previous programming will be lostUsing the Supplied Overlays CloningAdvanced Programming with DD4 Software Battery Replacement Conserving Battery PowerTroubleshooting Unit does not respond to any key presses Specifications