Xantech URC-2 Quick Start, Installing Batteries, Teaching Single IR Commands

QUICK START

Perform the following basic steps to begin using the URC-2 immediately.

Installing Batteries

1.Turn the unit over and remove the battery cover. Press the cover Tab in the direction of the arrow on Tab and lift up. See Fig. 3.

Tab	Battery Cover	Batteries	Battery Cover
Press in direction of		Installed	(removed)
arrow on tab and lift up.		Be sure to observe
		correct polaity!
Back Side
of URC-2

Fig. 3

Fig. 4

2.Install 4 “AAA” Batteries (Alkaline recommended). Refer to Fig. 4. Be careful to observe correct polarity for each battery as shown and as marked on the inside of the battery compartment.

3.Reinstall battery cover.

Teaching Single IR Commands

1. Place the URC-2 and the "teaching" remote on a flat

surface, facing each other as shown in Fig. 5.

"Teaching" Remote

2.Place the Programming Overlay #1 (supplied) over the bottom three rows of keys on the URC-2. Refer to Figs.

2 & 6. NOTE: Do not remove the adhesive backing from this overlay for permanent attachment unless you have no intention of using the other overlays in the future.

3.Press and release the PGM Key & any desired Source Key both at the same time. Refer to Fig. 6.

The Status LED will blink Green and the Source LED will be steady Red.

4.Press and release a Source Key twice (or a Function Key once for the selected source) under which you wish to place an IR command.

The Status LED will be a steady Green, waiting for an IR signal.

NOTE: It is necessary to press different Source Keys twice, once to select the bank, the next to select it as a key to learn IR data.

5.Press briefly the desired key on the "Teaching" Remote.

The URC-2 Status LED will blink Amber briefly, indicating the command was learned, then blink Green, waiting for your choice of another key.

URC-2

			inches
		2		50	mm)
	to		to
0
	(0

Fig. 5

Status LED
will blink				URC-2
Green
	TV	VCR	SAT	CBL
	DVD	TNR	CD	AUX
Press and	POWER	T/V	MUTE	VOL
Release the	1	2	3	VOL
PGM and a
Source Key	4	5	6
simultaneously	7	8	9
to enter the				CH
Program Mode		0		CH
	ENTER		PR.CH
(single	GUIDE			MENU
commands
		PAUSE
per key).	REW		SEL	FF
			PLAY

Controllers

NOTES:		EXIT	STOP		INFO
a) If the Status LED blinks Red two times, then steady Green, an		PGM	CANCEL	DEL	XFER
errror has occurred and the command has not been learned.	Programming
When this happens, simply repeat step 5, but this time vary the		A	B	C	D
	Overlay used
		SEQ	DELAY	EDIT	STEP
distance and/ or the length of time you press the key on the	(#1)
"Teaching" Remote.				Fig. 6
					3
URC-2