Cloning, Using the Supplied Overlays

CLONING

When you have finished programming and have checked all commands for proper operation, you are now able to copy (clone) the contents to other URC-2's, if desired. This will save you the tedium of repeated programming when you want identical commands in additional URC-2's. Refer to Fig. 13 and proceed as follows:

1.Using a 3' COM Port cable (optional, see your dealer) , simply plug it into the COM Port of each unit as shown in Fig. 13.

2.On the programmed unit, press both the PGM and the XFER keys simultaneously, then release. Refer to Fig. 14.

Programmed Unit	Un-programmed Unit
COM Ports
UP	URC-2's	UP
(Battery Covers Removed)

3' cable (optional)

Fig. 13

The Status LED will flash Green and Amber alternately on both units while a copy of the memory contents is transferring to the unprogrammed unit. You may "clone" as many URC-2's as desired by repeating this process.

NOTE: If transfer does not complete or the Status and Source LED's blink Red, remove a battery from each unit, reinsert and try again.

USING THE SUPPLIED OVERLAYS

There are six overlays supplied that fit over the twelve lower "Custom Use" keys on the URC-2 (Fig. 15).

The Status LED will blink Green & Amber on both units during the Cloning process.

URC-2

TV VCR SAT CBL

DVD TNR CD AUX

POWER T/V MUTE VOL

VOL

•Overlay #1 is used specifically when programming, as explained previously (Figs. 2 & 6).

1 2 3

4 5 6

7 8 9

•Overlays #2, #3, #4, & #5 may be used to identify IR commands needed for advanced custom installation applications, or simply a few keys you can use for extra commands you may want that cannot be placed logically on other keys.

•When you have picked the overlay you want to use, peel off the protective adhesive cover and press it into place over the 12 keys.

CAUTION: The Programming Overlay (#1) would not normally be permanently attached, unless you have no intention of using the other overlays at a later time. Also, be sure to keep the Programming Overlay (#1) for future programming needs.

CLONINGCH

	ENTER	0	PR.CH
	GUIDE				MENU
			PAUSE
Press	REW		SEL		FF
PGM and XFER	REW		PLAY		FF
PGM and XFER			PLAY
simultaneously,	EXIT		STOP		INFO
then release
	PGM	CANCEL		DEL	XFER
	A	B		C	D
	SEQ	DELAY		EDIT	STEP

Fig. 14

• Be careful to align the overlay accurately, so that it does not interfere with the operation of the keys.

PGM

CANCEL

DEL

XFER

DRAPE

LIGHTS

PIP

FREEZE

OFF

SEQ

DELAY

EDIT

STEP

OFF

DISP

SWAP

SLEEP MODE

Programming

Scene Control

TV Functions

Overlay

REAR

CENTER

DELAY

SUB

TREB

BASS

BAL

MUTE

SURR

MODE

SLEEP

TEST

OFF

GLOBAL

OFF

Surround Sound

Audio Functions

Blank

Fig. 15

Overlay



URC-2