Xantech URC-2 installation instructions Inserting a Delay, Restore, Clearing all Memory

9.When stored, the Status LED will flash Amber, then go Green. You may now STEP to the next command.

NOTE: You do not have to delete anything to add a new command to the sequence.

Inserting a Delay

A delay may also be inserted in a similar manner.

10.Step through the sequence to a place just ahead of the command where you wish to insert a delay.

11.Press the DELAY key. The Source LED will blink Amber.

12.Enter the desired delay time (see Programming Delays, step 3).

13.Press CANCEL once to exit Delay Mode. The Source LED will turn Green, indicating the delay is now stored. You may now STEP through the remaining commands in the same manner until done.

NOTE: If you wish to step through the sequence again for further checks and editing, simply press CANCEL, then the target key, then the STEP key.

Status LED

will go off URC-2

	TV	VCR	SAT	CBL
	DVD	TNR	CD	AUX
Press CANCEL
once, then	POWER	T/V	MUTE	VOL
Press and	1	2	3	VOL
Release the
CANCEL Key	4	5	6
and the active	7	8	9	CH
Source Key				CH
simultaneously	ENTER	0	PR.CH
to leave the	GUIDE			MENU
EDIT Mode		PAUSE
	REW	SEL		FF
		PLAY
	EXIT	STOP		INFO
	PGM	CANCEL	DEL	XFER

A B C D

SEQ DELAY EDIT STEP

Fig. 11

When you have finished editing, exit the EDIT Mode completely by

pressing CANCEL once, then CANCEL and the active Source Key simultaneously. The Status LED will go out. Refer to Fig. 11.

Restore

In rare instances, while programming the URC-2, or cloning from one to another, the unit may lock up and not respond to any key presses. If this occurs, temporarily remove one battery, then reinstall it. This will reset the unit and restore operation. No user programming will be lost.

Controllers

Clearing all Memory

If, for any reason, you wish to clear all programming from the unit, press the PGM and the SEQ keys simulta- neously, then release. Within 1 second, simultaneously press the DEL and EDIT keys and release. Refer to Fig. 12. The active Source (bank) LED will blink once to confirm the action.

•Bear in mind that all previous programming will be lost!

•You may now proceed to reprogram the URC-2 from scratch.

The Active				URC-2
Source LED
will go	TV	VCR	SAT	CBL
Off and On
to confirm	DVD	TNR	CD	AUX
memory clear
	POWER	T/V	MUTE	VOL
	1	2	3	VOL
	4	5	6
	7	8	9	CH
		0		CH
	ENTER		PR.CH
TO CLEAR	GUIDE			MENU
		PAUSE
ALL MEMORY	REW	SEL		FF
		PLAY
	EXIT	STOP		INFO
1
Press	PGM	CANCEL	DEL	XFER

PGM and SEQ

simultaneously, A B C D

then release SEQ DELAY EDIT STEP

2

Within 1 Second

Press

DEL and EDIT

simultaneously,

then release

Fig. 12

	
		7
URC-2