TView Micro SXGA User’s Guide
Perform the following steps to connect the TView Micro SXGA to a PC or Macintosh Desktop or Laptop:
1.Turn the computer and monitor off.
The computer must be off when connecting the TView Micro SXGA .Connecting with the power on could result in static damage to your computer and video equipment.
2.Disconnect the current monitor cable from the "monitor out" port at the rear of the computer.
3.Locate the Video In cable (labeled “VGA Input”) attached to the rear of the TView Micro SXGA unit.
4.For an IBM PC or compatible, connect the cable connector located at the other end of the VGA Input cable to the "monitor out" port at the rear of the computer, the same port from which you disconnected the current monitor cable in step 2. For a Macintosh or compatible, using a Macintosh video adapter, connect the other end of the VGA Input cable to the Macintosh Video Output port located at the rear of the computer, the same port from which you removed the current monitor cable in step 2.
5.Connect the male end of your computer’s monitor cable to the female connector on the VGA input cable.
6.Connect the power adapter to the rear of the TView Micro SXGA, labeled 5V DC. Plug the adapter into the nearest wall outlet. The LED at the front of the unit will illuminate; indicating the TView Micro SXGA is ON. For the meanings of each LED
12Hardware Installation