DirecTV H20 manual Fine-Tuning the Signal, Running the System Test, First make sure that

solve your	Test may help
tips helped	the System
If none of the preceding	troubleshooting issues, to figure things out.

Fine-Tuning the Signal

If you self-installed your satellite dish antenna, you may have already used the Satellite Setup section of Guided Setup to fi nd the dish-pointing coordinates, acquire and fi ne-tune the signal and run a system test. If you need to run Satellite Setup again, press MENU. Select Settings from the Quick Menu, then select Setup. When the System Setup screen is displayed, press SELECT on Satellite in the left menu, then select the Repeat Satellite Setup button.

Running the System Test

The System Test allows you to run a basic diagnostics check on your DIRECTV HD Receiver. If you are experiencing any trouble with your receiver, run the system test. It will also allow you to get your access card and receiver ID numbers or to initiate diagnostic procedures on your digital satellite receiver.

First make sure that:

4All connections — jacks, cables, etc. — are in place correctly (see Chapter Two, Getting Connected, for more information)

4There are batteries in the remote control, and they are working correctly

4The access card is installed in the DIRECTV HD Receiver.

Follow these steps to run the diagnostics system test on your DIRECTV HD Receiver.

1)Turn on your TV and the DIRECTV HD Receiver.

2)Slide the mode switch to the DIRECTV position to put the remote control in satellite receiver-controlling mode, then press MENU to display the Quick Menu.

3)Select Settings.

4) Select Setup, then Info & Test. 43