Humax COMBO-9000 manual Software Update, OTA Over The Air

7. Installation

7.3Software Update

In order to maintain proper performance of the product, it is essential to have the most up-to-date software. Visit the Humax website to check the latest news and newly released software versions.

– http://www.humaxdigital.com.

It is recommended that you periodically check for the availability of software update.

1.Press the MENU button.

2.Select Installation using the ￿/￿ button and press the OK or ￿ button.

3.Select Software Update using the ￿/￿ button and press the OK or ￿ button.

1. OTA (Over The Air)

OTA, an abbreviation of Over–the-Air, is a standard for the transmission of software through a broadcast system. OTA is simply an alternative method for downloading software versions. However, the manufacturers reserve the right for deciding the release of the software for their products by beaming the latest version of software over the air via aerial. The software update via aerial will only occur under the following circumstances.

1.The equipment should have the appropriate loader software.

Caution: Please note that if the normal loader software is not equipped, the product may not be updated or operate properly after software update.

2.The manufacturer decides to release the software via a designated channel.

3.The equipment must be tuned properly to the same aerial equivalent to that of the manufacturer.

4.Update software when the signal strength and quality is high. If the signal strength and quality are not recommendable, perform the software update later.

Caution:

•Please be careful to keep the power on and the power cord plugged in during software update. If the power is off during software update, fatal damage may be caused to the product.

•Please be careful not to pull out the signal line (co-axial cable) during software update. Update may be interrupted and the product may not operate.

GB58

User’s Manual