IB5400GB 3/09/01 16:14 Page 27
S peakers
Speaker icons display and size
•If the speaker is connected, display the corresponding icon
•If the speaker is capable of reproducing low frequencies (<100 Hz), select the large icon.
•If the speaker provides poor quality at low frequencies (<100 Hz), select the smaller icon.
• If the subwoofer is not connected, select the large icon for the front speakers (LH/RH).
Note: The speaker icon size setting (large/small) has no effect on DVD discs in MPEG 2 Multichannel Audio.
Delay between speakers
GB
•Delay settings allow you to adjust the virtual space between front and rear speakers. This means you can reproduce the sound space of a movie in your home.
•If the surround speakers or the central speaker cannot be installed at the same distance from the listening position as the front speakers, change the delay to obtain a better surround effect.
•If the distance (D2) from the listening position to the central speaker or the distance (D3) from the listening position to the surround speakers is greater than or equal to the distance (D1) from the listening position to the front speakers, no adjustments are required. Otherwise, adjust the settings according to the chart below:
| Centre |
Front speaker (L) | Front speaker (R) |
| C |
L | R |
| D2 |
D1 | D1 |
| SW |
D3 | Subwoofer |
D3 | |
SL | SR |
Speaker | Delay time | Distance between | |
D1 and D2/D3 | |||
|
| ||
|
|
| |
| 1.3 ms | approx. 150 cm | |
Central | 2.6 ms | approx. 100 cm | |
speaker (D2) | 3.9 ms | approx. 150 cm | |
| 5.3 ms | approx. 200 cm | |
|
|
| |
Surround | 5.3 ms | approx. 200 cm | |
10.6 ms | approx. 400 cm | ||
speakers (D3) | |||
15,9 ms | approx. 600 cm | ||
| |||
|
|
|
Surround | Surround |
speaker (L) | speaker (R) |
Relative volume setting between speakers
When listening to the test signal, adjust the volume of the central, surround (LH), surround (RH) speakers and the
To play the test signal
1.Select the “TEST” box and press ok (15) to confirm. The test signals will be played in each speaker in a clockwise direction.
2.When the audio signal is played on a speaker, select the appropriate volume level for that speaker from
3.Confirm the selected volume level with ok (15) . (Test signals stop.)
* 6dB corresponds to a power increase or reduction by 4 (3dB, by 2).
27