Technicolor - Thomson ITC250 manual Picture in picture PIP, Overview menu, Split screen mode

itc250-en 6/04/04 11:57 Page 17

PIP	Return
	Display mode
	Programme

Zoom Position

PIP	Return
	Display mode

Programme

Advanced functions

Whenever you enable the parental control function by defining a personal code you have to enter your code to access the Parental control and Installation menus, even if there is no lock on. In the Parental control menu the option is replaced by Deactivate parental control.

To disable the parental control function, access the Parental control menu by entering your personal code, select the Deactivate parental control option and enter your code again.This option is then replaced by Activate parental control.

The personal code is deleted every time you disable the parental control function.This
means you have to redefine it every time you enable this function again.
		EN
Whenever you enter your code all the locks are disabled until the set is put in standby
again.
If you have forgotten your PIN code you can cancel it:
When you are prompted to enter your code to access the Parental control menu,
press the PR+ and	+ buttons on the front of your set at the same time for eight
seconds.This procedure is possible, even if you have locked the buttons on the front of
the TV set.

Picture in picture (PIP)

	Press the MENU button to display the OVERVIEW menu. Select Picture in Picture
	and press OK.The menu displays. Under the Display mode option, select one of the
	following PIP display modes:
	Off: PIP is disabled.
	Single: a channel or av programme is displayed in a frame in a corner of the screen.
	Split screen: the screen is divided vertically in two and the PIP is displayed on the right
	side. Sound comes from the main programme, on the left.
PIP...	When you enable the PIP function, the other options in the menu are displayed.
01
Minimum...	- In Single mode, you can select the programme, the zoom and the position of the
Upper right...
	frame on the screen. Select an option from the list each time using the	buttons.
	- In Split screen mode, you can select the programmes to be displayed in both
	pictures. Use the PR+/PR- buttons to change programmes on the left side of the screen
	and use the PIP+/PIP- buttons to change programmes on the right side of the screen.
	Use the SWAP button to swap pictures.
	Press EXIT to close the menu. Select the option Return and press OK to return to the
	OVERVIEW menu.
Split screen...	Operation (TV mode)
01
	Use the PIP button on the remote control to enable the different display modes in turn.
	In both display modes:
	- Use the SWAP button to swap the channels around.
	- Press the FREEZE button to freeze the main picture.
	- To apply the PIP function to an AV programme in RGB, you need to select RGB as the
	relevant AV source in the AV Settings menu (see page 19).
	In Single mode:
	- Use the PIP ZOOM button to change the size of the PIP picture.
	In Split screen mode:
	- Teletext on the channel displayed on the left appears on the right side of the screen. Press
	EXIT to disable this function.
	Use the PIP+/PIP- buttons to change programmes on the right side of the screen.

17