Samsung SV-7000W manual VCR Plus+ Set up America Only

00407A)SV-7000W-GB-2_sea 7/24/01 11:16 AM Page 27

VCR Plus+ Set up (AMERICA Only)

With VCR Plus+, each channel is assigned a VCR Plus+ guide number, which can be found in most TV program guides. If your VCR comes with VCR Plus+, you can use this system when recording. Before using VCR Plus+, set the channel and VCR Plus+ numbers to match.

*VCR Plus+ is trademark of Gemstar Development Corporation. Be sure to select the correct signal source (Antenna/Cable TV depending on your hook-up) before performing Guide Channel Setup.

1Press MENU for the Main Menu. Press and to select “INSTALLATION”. Press and to select “MANUAL SET UP”.

2Press to select “GUIDE CH SET UP”.

3VCR Plus+ Guide channel numbers appear on the top row. Receiving channels are on the bottom.

Press or to select a VCR Plus+ Guide channel number.

4Press or for the correct receiving channel number. For example : If receiving channel 23 corresponds to the

VCR Plus+ Guide channel 45, press and until 45 appears in the top row of numbers with the downward pointing arrow directly below.

Press the and until 23 appears on the bottom row.

The channel number that changes is always the receiving channel rather than the VCR Plus+ Guide channel.

5Press or to select the next VCR Plus+ Guide channel number. Enter all the receiving channel numbers and press MENU to finish.

GB

	** INSTALLATION **
	COUNTRY
	ANT./CATV:ANTENNA
	AUTO SET UP
	¨ MANUAL SET UP
¹	¨	END:(MENU)

** MANUAL SET UP **
¨ GUIDE CH SET UP
	CH ADD/DELETE
	RF OUT M/G/I/K		:M
	RF OUT CH 116-125:60
¹	¨	END:(MENU)

** GUIDE CH SET UP **
40	41	42	43	44	45
40	41	42	43	44	45
	ENTER ACTUAL
	RECEIVING CHANNEL
¹	¨		END:(MENU)

** GUIDE CH SET UP **
40	41	42	43	44	45
40	41	42	43	44	23
	ENTER ACTUAL
	RECEIVING CHANNEL
¹	¨		END:(MENU)

27