Setup Menu
Basic Operation
1Press SETUP in the STOP mode to enter the Setup Menu.
2Press ENTER/OK to go to the next level submenu or confirm your selection.
3Press 1 2 to enter the submenu or return to the previous menu.
4Press 34 to highlight the desired menu.
5Press SETUP to quit the setup menu.
➜ When you quit the setup menu, the settings will be stored in the player’s memory even if the player is switched to power off.
PROGRAM (not for Picture CD/MP3)
1press 34 to choose “PROGRAM”.
2Press 2 to move the cursor to the field of the submenu to choose the item Input menu.
➜ Input menu: Enter the Program item.
3Press ENTER/OK to enter the program page.
General Setup menu
Some settings need to be made in this menu. They are: “DISC LOCK”, “PROGRAM”, “OSD LANGUAGE” and “SCREEN SAVER”.
Follow the steps below:
GENERAL SETUP PAGE
DISK LOCK
PROGRAM
OSD LANGUAGE
SCREEN SAVER
1Press SETUP to enter the setup menu.
2Press 1 2 to choose the GENERAL SETUP icon 
.
DISC LOCK
When the disc is locked, the player will store its specific code into the memory for future identification. For the next playback, the DVD player will prompt you to enter the password. Then, press ENTER/OK to load the disc.
1Press 34 to highlight “DISC LOCK”.
2Enter its submenu by pressing 2.
➜Lock: Lock the disc being played.
➜Unlock: unlock the disc.
3Press 1 to return to the General Setup Page.
Input your favorite track
1Input valid track number by pressing the numeric buttons.
2Press 341 2 to move the cursor to the next selected position.
➜ If the track number is more than ten, press 2@ to open the next page and go on programing, or press 341 2 to highlight NEXT button, and then press ENTER/OK.
3Repeat this steps to input another track number until the whole program is completed.
Remove a track
1Press 341 2 to move the cursor to the track you want to remove.
2Press ENTER/OK or PLAY to remove this track from the program menu.
Playback tracks
When programing is completed,
1Press 341 2 to move the cursor to the START button.
2Press ENTER/OK.
➜ DVD player will playback the selected tracks under the programed sequence.
Quit the program playback
In the Program menu,
1Press 341 2 to move the cursor to the EXIT button.
2Press ENTER/OK to quit this menu.
Stop the program playback
●During playback of the programmed tracks, press STOP once. Then after you press PLAY, the DVD player will start
●Press STOP twice to cancel the
Repeat the program playback
●During playback of the programmed tracks, press REPEAT. The programed tracks can be played again.
Note: If you select Shuffle mode by pressing REPEAT several times, the DVD player cancels program playback.
14