CHANNEL SET UP
You can program the tuner to scan all the channels you receive in your area.
NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the TV/VCR channel selector to the output channel of the cable box or satellite box (Ex CH3). Then select the channel to be viewed on the Cable Box or Satellite Box.
Make sure ...
•Press the POWER button to turn on the TV/VCR.
DELETING (OR ADDING)
CHANNEL
The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.)
1 Select “CHANNEL SET UP” | – M E N U – |
| |
Press the MENU button on the | TIMER PROGRAMMING |
PICTURE CONTROL | |
SETTING CLOCK | |
remote control. Then press the | B CHANNEL SET UP |
USER’S SET UP | |
PLAY/K or STOP/L button to | LANGUAGE [ENGLISH] |
ZERO RETURN | |
TIME SEARCH | |
point to “CHANNEL SET UP”. |
|
Then, press the F.FWD/B button. |
|
1Select “CHANNEL SET UP”
Press the MENU button on the remote control.
Press the PLAY/K or STOP/L but- ton to point to “CHANNEL SET UP”.
Then, press the F.FWD/B button.
– M E N U –
TIMER PROGRAMMING PICTURE CONTROL SETTING CLOCK
BCHANNEL SET UP USER’S SET UP LANGUAGE [ENGLISH] ZERO RETURN
TIME SEARCH
2 Select “ADD/DELETE CH” | – CHANNEL SET UP – |
Press the PLAY/K or STOP/L but- | B ADD / DELETE CH (CATV) |
ton to point to “ADD/DELETE | AUTO CH PROGRAMMING |
| |
CH”. |
|
Press the F.FWD/B button. |
|
2Begin auto ch programming
– CHANNEL SET UP –
Press the PLAY/K or STOP/L but-
ADD / DELETE CH (CATV)
ton to point to “AUTO CH PRO- B AUTO CH PROGRAMMING GRAMMING”.
Then, press the F.FWD/B button. The tuner scans and memorizes all the active channels in your area.
3Enter the desired channel number
Press the PLAY/K or STOP/L but- ton until your desired channel num- ber appears. (You can also use the number buttons or the CHANNEL K/L button to enter it.) (Example: CH8)
08
ADD / DELETE
3After scanning
The tuner stops on the lowest memorized channel.
•When AUTO CH PROGRAMMING is activated where there is no TV signal input, “NO TV SIG- NALS” will appear on the display after the com- pletion of the channel scanning.
•The TV/VCR may recognize TV channels to be CATV channels by the receiving conditions. In this case, try auto ch programming again in the fine receiving conditions.
4Delete (or add) it from (into) memory
Press the F.FWD/B or REW/s button. The channel number changes to light red. The channel is deleted from memory.
•To delete another channel, repeat steps [3] and [4].
•If you press the F.FWD/B or REW/s button again, the channel is memorized again.
Added channel: Light blue.
Deleted channel: Light red.
5Exit the channel setup mode
Press the MENU button on the remote control to returns to TV mode.
NOTE: To confirm that channel(s) has been deleted or added, press the CHANNEL K or L button.
- 14 - | EN |
9J27