Symphonic SC309E owner manual Preparation for USE, ANTENNA/CABLE Connections

PREPARATION FOR USE

From Cable System or

Satellite Dish

Satellite Box or

Cable Box	OUT
(Not supplied)	IN

Dipole Antenna	VHF/UHF Antenna
(Supplied)
	(Not supplied)
Flat twin-lead cable
Matching Adapter	VHF Antenna
	(Not supplied)
(Supplied)

From			UHF Antenna
		or	(Not supplied)
Cable System
		VHF/UHF
		or Combiner
	or	(Not supplied)
75-ohm Coaxial		ANT.
Cable (Not
supplied)			Flat twin-lead cable Fig.4
		or

ANTENNA/CABLE

CONNECTIONS

DIPOLE ANTENNA HOOK UP

1.Push the stem of the Dipole Antenna (supplied) into the hole for antenna at the back of TV/VCR.

2.Connect the flat twin-lead cable from the Dipole Antenna to the 300/75 ohm Matching Adapter (supplied).

3.Plug the Matching Adapter to ANT terminal of TV/VCR as shown in drawing.

For the best reception, extend the Dipole Antenna and adjust its length and position. (Avoid handling the top section when making adjustments.)

NOTE: If it is difficult to get good reception with the indoor antenna, the use of an outdoor antenna is rec- ommended. Before an outdoor antenna is connected to the set, the indoor antenna should be disconnected.

VHF/UHF COMBINED ANTENNA

A VHF UHF 75 ohm combination antenna can be connected to ANT terminal.

VHF/UHF SEPARATE ANTENNAS

In some areas it will be necessary to use an outdoor antenna.

CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX

Use this connection if your cable system connects directly to your TV/VCR without a converter box. By using this connection you can:

1)Use the TV/VCR remote to select channels.

2)Program one or more unscrambled channels for Automatic Timer Recording.

NOTE: This unit will ONLY record and view the same channel.

CABLE WITH CONVERTER/ DESCRAMBLER BOX OR SATELLITE BOX

If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown in drawing.

By using this connection you can also record scram- bled channels. However, channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the TV/VCR Remote Control. Unattended timer record- ing is limited to one channel at a time.

TO RECORD A SCRAMBLED/UNSCRAMBLED CHANNEL

1.Set the TV/VCR channel selector to the output channel of the Cable Converter Box or Satellite Box. (Ex. CH3)

2.Select the channel to record from your Cable Converter Box or Satellite Box.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connect- ed to the grounding system of the building as close to the point of cable entry as practical.

- 9 - EN

9J27