Emerson EWC0903 owner manual Preparation for USE, Antenna/Cable, Connections

PREPARATION FOR USE

	From Cable System or				Dipole Antenna
	Satellite Dish							VHF/UHF Antenna
					(Supplied)
Satellite Box or								(Not supplied)
Cable Box
	OUT				Flat twin-lead cable
		IN
(Not supplied)
								VHF Antenna
						Matching Adapter		(Not supplied)
						(Supplied)		UHF Antenna
From
						or		(Not supplied)
Cable System
						or	VHF/UHF
							Combiner
	75-ohm Coaxial			ANT.			(Not supplied)
	Cable (Not
	supplied)		or			or	Flat twin-lead cable
	ANTENNA/CABLE					CABLE WITHOUT CONVERTER/
						DESCRAMBLER BOX
	CONNECTIONS
						Use this connection if your cable system connects
DIPOLE ANTENNA HOOK UP						directly to your TV/VCR without a converter box.
1. Push the stem of the Dipole Antenna (supplied)						By using this connection you can:
						1) Use the TV/VCR remote to select channels.
into the hole for antenna at the back of TV/VCR.
						2) Program one or more unscrambled channels for
2. Connect the flat twin-lead cable from the Dipole
						Automatic Timer Recording.
Antenna to the 300/75 ohm Matching Adapter
						NOTE: This unit will ONLY record and view the
(supplied).
						same channel.
3. Plug the Matching Adapter to ANT terminal of
						CABLE WITH CONVERTER/
TV/VCR as shown in drawing.
For the best reception, extend the Dipole Antenna						DESCRAMBLER BOX OR SATELLITE
and adjust its length and position. (Avoid handling						BOX
the top section when making adjustments).						If your cable service supplies you with a converter
						box or if you use a satellite system, you can use the
NOTE: If it is difficult to get good reception with						basic connection shown in drawing.
the indoor antenna, the use of an outdoor antenna is						By using this connection you can also record scram-
recommended. Before an outdoor antenna is connect-						bled channels. However, channel selection must be
ed to the set, the indoor antenna should be discon-						made with the converter box or satellite box. This
nected.						means that channels cannot be changed using the
VHF/UHF COMBINED ANTENNA						TV/VCR Remote Control. Unattended timer record-
						ing is limited to one channel at a time.
A VHF UHF 75 ohm combination antenna can be						TO RECORD A SCRAMBLED/UNSCRAMBLED
connected to ANT terminal.
						CHANNEL
VHF/UHF SEPARATE ANTENNAS						1. Set the TV/VCR channel selector to the output
						channel of the Cable Converter Box or Satellite
In some areas it will be necessary to use an outdoor
						Box. (Ex. CH3)
antenna.						2.Select the channel to record from your Cable
						Converter Box or Satellite Box.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connect- ed to the grounding system of the building as close to the point of cable entry as practical.

- 9 - EN

9J27