| Timer Recording (cont’d) 35 |
Checking or Clearing Timer Recordings | 5 2-4 |
1 |
With the TV/VCR on, press the MENU button.
2 | 1 | EJECT | POWER | |
| |
MENU | STATUS/EXIT | CLEAR |
Press the PLAY/▲ button or the STOP/▼ button to select | | | |
VCR PROGRAM, then press the F.FWD/B button. | 1 | 2 | 3 |
3 | | 4 | 5 | 6 |
| 7 | 8 | 9 |
Press the PLAY/▲ button or the STOP/▼ button to select | | SLEEP/ | | ALT.CH |
PROGRAM REVIEW, then press the F.FWD/B button. | | WAKE UP | 0 |
| | |
| | | |
The timer recording information for the program in the lowest | | REC | | PAUSE |
numbered position will appear on the screen. If no timer record- | | /OTR | | /STILL |
| | PLAY | |
ings are programmed, nothing will happen when you select PRO- | | REW | F.FWD |
| |
GRAM REVIEW and press the F.FWD/B button.
4
Press the F.FWD/B button to display information about the next timer recording. (If you do not press a button within 10 sec- onds, information about the next timer recording will appear auto- matically.) This will continue until all positions have been displayed. Then, the menu will disappear. You can exit the Program Review at any time by pressing the STATUS/EXIT button.
STOP
CH.VOL.
MUTE
SPEED
TRACKING MEMORY
5
To cancel the timer recording displayed, press the CLEAR button. Either the display will disappear or information about other timer recordings will appear. If you do not press any other buttons, the display will disappear after all timer recordings have been displayed.
6
Repeat steps 1-4 to make sure you cleared the correct recording.
Helpful Hint
• With ShowGuard, you don’t have to worry about losing your timer recordings. If the power fails, timer recordings will be restored when the clock is reset. (The clock will reset itself automatically if you are using AUTO CLOCK. Details are on pages 14-17. If you are not using AUTO CLOCK, reset the clock manually. Details are on pages 12-13.) The timer recording will not occur only if it was scheduled to take place during the power failure.
Tvcr
For Customer Use
Warranty Verification
Declaration of Conformity
Features
Safety Precautions
Introduction
Table of Contents
Replace the battery compartment lid
Battery Safety
Using the Remote Control
TV/VCR Maintenance
Rod Antenna
Hook up your TV/VCR using one of the connections shown
Hooking Up the TV/VCR
RF coaxial cable Not supplied
Cable Plug
Hooking Up the TV/VCR cont’d
Bent pin
Crooked Pin Straight Pin
Press the Menu button. The screen shown below will appear
Turning On the TV/VCR
Select Language English Español Select KL To END Press Exit
Language Selection
Press the Menu button
Wait for the TV/VCR to set up channels
Automatic Channel Setup
Programming of the channel you added or deleted will appear
Adding/Deleting Channels
Press the PLAY/o button or the STOP/p button to select
Repeat steps 3-4 to add or delete other channels
Cable Box users must set the clock manually
Setting the Clock
Manual Clock Setting
Date Sunday To Correct Press Clear To END Press Exit
SET Manual Clock Time Date To END Press Exit
SET Manual Clock Time
Month To Correct Press Clear To END Press Exit
Automatic PBS Channel Selection
Setting the Clock cont’d
PRIM. Setup Press B
VCR Program VCR Setup Caption Reminder Brightness
SET Auto Clock Time
NOW Searching flashes on the TV/VCR screen
Wait for the TV/VCR to find the time
SET Auto Clock Time Date NOW Searching To END Press Exit
Manual PBS Channel Selection
Use the Number buttons to select your PBS station
Press the PLAY/ button or the STOP/ button to select
PRIM. SETUP. Then, press the F.FWD/B button
PRIM. Setup Press B VCR Program VCR Setup
Daylight-Savings Time
Press the Menu button, then press the STATUS/EXIT button
Primary Setup
Volume BAR SET Clock Select KL Choose B To END Press Exit
Time Zone
Front Panel
Connect your antenna or cable here. Details are on page six
AC Power Cord
Rear Panel
ANTenna Jack
Remote Control Buttons
STOP/ Button
Menu Button
STATUS/EXIT Button
REWind/ Button
When you finish, press the STATUS/EXIT button
Adjusting the Picture Controls
Decreased brightness
Adjusting the Picture Controls cont’d
Tint KK Sharpness TV Reset
Decrease Increase
If you select Status OFF
On-Screen Status Displays
If you select Status ON, then select Counter only OFF
If you select Status ON, then select Counter only on
OFF
Reminder
Insert a tape in the TV/VCR
Playing
Follow the steps below to play a tape
Hrs
Recording
Read and follow the steps below to record a TV program
To stop recording, press the STOP/ button Tape Speeds
Press the STOP/EJECT but- ton on the TV/VCR to stop the OTR
Length Press OTR Cancel Press Clear
One-Touch Recording
Tape is in the TV/VCR. The record tab must be intact
Rerecording Tape Duplication
TV/VCR is now in Line Input mode
Select Program Number To END Press Exit
Timer Recording
Daily
Time OFF To Correct Press Clear To END Press Exit
ONE Time Program Channel Time on
Timer Recording cont’d
Gram Review and press the F.FWD/B button
Timer recording information for the program in the lowest
With the TV/VCR on, press the Menu button
Program REVIEW, then press the F.FWD/B button
REC Defeated
VCR Setup ONE Time Play
Defeat Recording
Follow the steps below to prevent accidental recording
TV programming will appear while the tape is rewinding
VCR SETUP, then press the F.FWD/B button
VCR Setup ONE Time Play Repeat Play on
Repeat Play
Insert a tape in the TV/VCR Press the Menu button
VCR Setup ONE Time Play Repeat Play A-B
B Repeat Play
Repeat
Repeat Play cont’d
Stop
Real-Time Counter Memory
Appear on the screen
Viewing a Still Picture
Forward and Reverse Searching SP/LP/SLP
Super High Speed Searching LP/SLP
Smartlock menu will appear
SmartLock
To block ratings, follow the steps below
Example Specific Sub-ratings
SmartLock cont’d
Ratings are defined on
After you enter the code, the Smartlock menu will appear
To change the access code, follow these steps
TV-Y7 TV-G
Blocked Ratings
Blue Background
VCR Program VCR Setup Caption Reminder
Press the SLEEP/WAKE UP button
Sleep Timer
Timer during a recording
Timer Sleep Wake UP
Wake Up Timer
Timer Sleep Wake UP TV on ON-TIME
VCR Program VCR Setup Caption
Volume Bar
Menu Screen
To Adjust Press / B Caption
Closed Caption
Example
Half-screen text
Closed Caption cont’d
Standard Closed Captions
Automatic Operation Features
Glossary
Helpful Hints
Helpful Hints cont’d
Specifications
Model # Serial #
Limited Warranty
Please contact Philips at French Speaking English Speaking
Index
Page
Supplied Accessories