V C R P L U S + 22
VCR PLUS+
Your TV/VCR Combo comes equipped with VCR Plus+ technolo- gy. This function allows you to program your VCR simply by entering the VCR Plus+ code number associated with the program you wish to record.
Note: Before VCR Plus+ can be used, VCR Plus guide channels must be programmed. See VCR Plus Guide Setup in “Initial Setup” page 14, if you have not yet programmed these channels).
TIMER RECORDING WITH VCR PLUS+
Press the VCR PLUS+ button on the remote control
The VCR PLUS+ code screen appears
- - - - - - - -
ENTER THE PLUS CODE
Enter the VCR PLUS+ code
1234
HOW OFTEN?
ONCE DAILY
SELECT |
|
RECORDING SPEED | SP EP |
IF ALL OK, | CANCEL BY |
PUSH VCR PLUS+ | CANCEL |
Note: If you enter the VCR Plus+ code incorrectly, press CANCEL on the remote. The first screen will reappear.
Press the DAILY/WEEKLY button to select how often a program should be recorded, ONCE, DAILY, or WEEKLY
Press the SP/EP button to select SP or EP recording speed. (See pg 20 for more on tape recording speeds)
Press the VCR PLUS+ button
The following screen will appear, displaying a summary of the informa- tion you just entered:
DATE | MON - FRI |
START | 2:30 PM |
STOP | 3:00 PM |
CHANNEL | 03 |
RECORDING SPEED | SP EP |
IF ALL OK, | CANCEL BY |
PUSH VCR PLUS+ | CANCEL |
|
|
If the settings are correct, press the VCR PLUS+ button again to accept. The following message will appear:
YOUR PROGRAM IS CONFIRMED
PUSH THE TIMER BUTTON
If you wish to make a correction, use the ( 
) buttons to move to the item and the ( 
) buttons to correct. Once corrected press VCR PLUS+ to accept the settings.
Press the Timer button
on the remote control.The timer is now in standby mode.
The REC lamp will glow green on the front panel of the unit, indicating the timer has been programmed. When the programmed start time arrives, the REC lamp will glow red and recording will begin. When the programmed stop time arrives, the lamp will go out and the recording will automatically stop. If there are other
NOTES:
VCR Plus+
Codes
VCR Plus codes for individual programs may be found in most local newspa- per television listings or in TV magazines. VCR Plus+ Codes are th three to eight digit number usually shown after the title or description of a program in TV listings.
You can program your VCR with up to six events. These events may be up t a month in the future. For more information on setting timer record ings, see "Regular VCR Programming" on page 20.
Note:
VCR Plus+ and PlusCode are registered trademarks of Gemstar Development Corporation. The VCR Plus+ system is manufac tured under license from Gemstar Development Corporation.