JVC TV 20240 manual Use

Page 3

6If an outside antenna is connected to the TV set, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection requirements for the grounding electrode.

7An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

EXAMPLE OF ANTENNA GROUNDING

AS PER NATIONAL ELECTRICAL CODE

8TV sets are provided with ventilation openings in the cabinet to allow heat generated during operation to be released. Therefore:

Never block the bottom ventilation slots of a portable TV set by placing it on a bed, sofa, rug, etc.

Never place a TV set in a “built-in” enclosure unless proper ventilation is provided.

Never cover the openings with a cloth or other material.

Never place the TV set near or over a radiator or heat register.

9To avoid personal injury:

Do not place a TV set on a sloping shelf unless properly secured.

Use only a cart or stand recommended by the TV set manufacturer.

Do not try to roll a cart with small casters across thresh- olds or deep pile carpets.

Wall or shelf mounting should follow the manufacturer’s instructions, and should use a mounting kit approved by the manufacturer.

USE

10Caution children about dropping or pushing objects into the TV set through cabinet openings. Some internal parts carry hazardous voltages and contact can result in a fire or electrical shock.

11Unplug the TV set from the wall outlet before cleaning. Do not use liquid or an aerosol cleaner.

12Never add accessories to a TV set that has not been designed for this purpose. Such additions may result in a hazard.

13For added protection of the TV set during a lightning storm or when the TV set is to be left unattended for an extended period of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage to product due to lightning storms or power line surges.

14A TV set and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the TV set and cart combination to overturn.

SERVICE

15Unplug this TV set from the wall outlet and refer servicing to qualified service personnel under the following conditions:

A.When the power cord or plug is damaged or frayed.

B.If liquid has been spilled into the TV set.

C.If the TV set has been exposed to rain or water.

D.If the TV set does not operate normally by following the operating instructions. Adjust only those controls that are covered in the operating instructions as improper adjust- ment of other controls may result in damage and will often require extensive work by a qualified technician to restore the TV set to normal operation.

E.If the TV set has been dropped or damaged in any way.

F.When the TV set exhibits a distinct change in perfor- mance — this indicates a need for service.

16Do not attempt to service this TV set yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

17When replacement parts are required, have the service technician verify in writing that the replacement parts he uses have the same safety characteristics as the original parts. Use of manufacturer’s specified replacement parts can prevent fire, shock, or other hazards.

18Upon completion of any service or repairs to this TV set, please ask the service technician to perform the safety check described in the manufacturer’s service literature.

19When a TV set reaches the end of its useful life, improper disposal could result in a picture tube implosion. Ask a qualified service technician to dispose of the TV set.

20Note to CATV system installer.

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Image 3
Contents Important Note to the Customer TV/VCR Combo USER’S GuideRisk of Electric Shock Do not Open Important Safety PrecautionsUSE Precautions about Video B L E O F C O N T E N T S Table of ContentsO N N E C T I O N S Connections Checklist Read ME FirstCable BOX Connection N N E C T I O N SConnecting to HEADPHONES/EARPHONES Connecting to a CamcorderRemote Control T T I N G S T a R T E DChanging the Batteries Changing Channels PowerAdjusting Volume E T T I N G S T a R T E DM O T E P R O G R a M M I N G Setting the Catv CodesOnscreen Menus S I N G T H E M E N UAuto Tuner Setup I T I a L S E T U PChannel Summary SET Lock Code N I T I a L S E T U PTo Set Local Channels for VCR PLUS+ VCR PLUS+ Guide SetupI C T U R E S E T T I N G S Balance U N D S E T T I N G SBass TrebleL O C K S / T I M E R S SET Clock SEMI-AUTOSET Clock Manual Closed Caption ON/OFF TimerM E R S / G E N E R a L I T E M S LanguageA S I C V C R F U N C T I O N S VCR Menu R M E N U I T E M SRepeat Play C R M E N U I T E M SRecording Speed Auto SP EPTimer Recording with VCR PLUS+ R P L U S +VCR PLUS+ Troubleshooting / I T R Timer Recording TroubleshootingInstant Timer Recording ITR Video Status Sleep TimerT T O N F U N C T I O N S T V Button Functions DisplayU T T O N F U N C T I O N S T Index Search Tracking AdjustmentT T O N F U N C T I O N S V C R VCR Functions BasicU T T O N F U N C T I O N S V C R Program Check REC/ITRSTOP/EJECT Problems Check Troubleshooting TTroubleshooting V C R Days I M I T E D W a R R a N T YIf YOU Ship the Product T H O R I Z E D S E R V I C E C E N T E R SE M O M O Model Specification S