Memorex MVT2135B Location of Controls, Cassette Loading Slot To insert or remove a video tape

Page 10

LOCATION OF CONTROLS

FRONT

REAR

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2

 

3

4

5

6

7

8

 

 

 

 

 

16

17

VolumeChannel

Stop/

Rew

Play F.Fwd Rec/Otr

Phones Power

Eject

 

 

Power Rec/OtrT-Rec

Video – In – Audio

9

10

11

12

13

14

15

DESCRIPTION OF CONTROLS

FRONT:

1.Cassette Loading Slot - To insert or remove a video tape.

2.Phones Jack - Plug monaural headphones or an earphone with an 1/8" miniplug into this jack for private listening.

3.Volume / Buttons - Press to raise or lower the volume of the sound.

4.Stop/Eject Button - Press once to stop the tape in any mode. Press again to eject the tape.

5.Play Button - Press to play a prerecorded tape.

6.Rec/Otr Button - Press once to start normal recording. Additional presses activate One-touch Timer Recording.

7.Power Indicator - Lights when the power is turned on.

8.T-Rec Indicator - This lights up when the TIMER REC button is pressed.

9.Power Button - Press to turn the TV/VCR on or off.

10.Channel / Buttons - Press to select a channel for viewing or recording.

11.Rew (Rewind) Button - In the Stop mode, this button rapidly winds the tape backwards. In the Play mode, this button activates reverse search.

12.F.Fwd (Fast Forward) Button - In the Stop mode, this button rapidly winds the tape forward. In the Play mode, this button activates forward search.

13.Remote Sensor - Signals from the Remote Control are received here.

14.Rec/Otr Indicator - Lights when the TV/VCR is recording.

15.Audio/Video In Jacks - Audio and video signal cables from an external source can be connected here.

REAR:

16.VHF/UHF Antenna Jack - Connect the 75 ohm coaxial cable from the antenna or Cable TV service to this jack.

17.AC Power Cord - Connect to a 120V, 60Hz outlet.

8

545A201A-E/P01-09

8

19*04*0, 17*19

Image 10
Contents MVT2135B MVT2195B English Power Sources CleaningAccessories Read InstructionsDamage Requiring Service POWER-CORD ProtectionPower Lines Replacement PartsHeat Safety CheckWall or Ceiling Mounting NEC SectionFeatures Table of Contents Moisture Condensation PrecautionsWhen YOU Experience the Above Conditions Moisture will Condense on the Unit in the Following CasesTo USE AC Power Source Power SourceAC Outlet Location of Controls AC Power Cord Connect to a 120V, 60Hz outletPower Indicator Lights when the power is turned on Cassette Loading Slot To insert or remove a video tapeRemote Control MenuArrow Polarity diagramBattery compartment Paying attention toMatching Antenna ConnectionsCombiner UHF 300 ohm VHF 300 ohm Indoor Antenna For Subscribers to Scrambled Cable TV Service For Subscribers to Basic Cable TV ServiceCable TV Connections Enter button Setting the LanguageNormal TV viewing Auto Clock Adjustment Auto Clock SettingAuto Clock Setting To SET Auto Clock to OFFPress the Enter button Press the Menu button. Press the SETPress the Menu button until the Menu screen is cleared To move cursor backward, press the Cancel button Manual Clock SettingExample Setting the clock to 830 AM, 23rd. MON October Press the SET/TRACKINGTo turn on the TV/VCR Adjust the volume level byTV Operation VHF/UHF ChannelsChannel + MutingCall TV/CAPTION/TEXT SleepQuick View Closed Captioning with a VCR What is Closed CAPTIONING?To View Closed Captions Selected mode TV/CATV modeTo Memorize Channels Channels available in your area Automatic Memory TuningScreen is cleared To ADD/DELETE Channels Using SET/TRACKING + orOr Channel + or button Enter the same password Setting the V-CHIPTo Register Password Again for the safety, thenTo SET the V-CHIP PG-13 Parental guidance Less than 13 years old Movie Rating is not setAll ages Under 17 years oldTo Change Password Desired hour, then press the Enter button To SET the on Timer+ or button to set Set the desired minuteTo SET the OFF Timer Example Turning off the TV at 1130 PMContrast Picture Control AdjustmentsBrightness Menu buttonColor Tint Sharpness CancelButton to adjust the sharpness of the picture Preset levels Press the Enter button until Sharpness appearsLoading Automatic Power on and PlayLoading and Unloading a Video Cassette UnloadingTo Prevent Accidental Erasure To Record Again Tape Speed and Maximum Playback / Recording TimeTo Stop Playback PlaybackTo Start Playback To play a prerecorded tapeDigital Tracki NG Control To Rewind or Forward the Tape RapidlyFORWARD/REVERSE Picture Search Speed Search Times Special PlaybackTo Visually Search for Desired Points Skip Search To Watch Still PictureSelect the Auto Repeat option Repeat mode is canceledTo Watch a Tape Repeatedly PositionRecording a TV Program Recording and Viewing the Same TV ProgramTo be recorded. Example Channel Screen and the Rec/Otr indicator will lightTo Stop Recording To Stop Recording Temporarily Press the REC/OTR buttonONE-TOUCH Timer Recording OTR TV/VCR channel cannot be changed during recordingThen press the Enter button Timer RecordingCheck the Timer REC SET option is selected Select the Program position, then pressWhen the programmed time is reached, To set the timer for another program, pressIndicator will light. The Timer is programmed Recording is automatically startedTo Confirm the Settings Other Functions for the Timer RecordingTo SET DAILY/WEEKLY Timer ExampleRecording Prog.1 Prog.2 Prog.3 Control Settings Program Deleted PartsTape Counter Using the Real Time Tape CounterTo View the Counter Display Counter toUsing Zero Return Connection to Camcorder Duplicating a Video TapeConnection to Another VCR Tion tab intact into the TV/VCRReception Disturbances IgnitionNo power Troubleshooting GuideSymptoms Cause Possible Solutions Power TV Broadcast ReceptionRecording Symptoms Cause Possible SolutionsRemote Control PlaybackVideo Head Cleaning Snowy PictureTelevision SpecificationsAccessories VCRMemo Español 545A201A K 00/03