Memorex MVT2135B Arrow, Paying attention to, Polarity diagram, Battery compartment, Cover

Page 12

REMOTE CONTROL

(CONTINUED)

BATTERY INSTALLATION

1	Slide the battery compart-
	ment cover in the direction

of the arrow.

BATTERY PRECAUTIONS

2	Install two “AAA” batteries,
	Install two “AAA” batteries,
	paying attention to the
	polarity diagram in the
	battery compartment.

3	Replace the compartment
3	cover.

The precautions below should be followed when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.

3.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)

EFFECTIVE DISTANCE OF THE REMOTE CONTROL TRANSMITTER

30˚ 30˚ 15 FEET

NOTES: •When there is an obstacle between the TV/VCR and the remote control, the remote control may not operate.

•When direct sunlight, an incandescent lamp, ﬂuorescent lamp or any other strong light shines on the Remote sensor of the TV/VCR, the remote operation may be unstable.

10

545A201A-E/P10-19

10

19*04*0, 17*13

Image 12

Contents MVT2135B MVT2195B English Cleaning AccessoriesPower Sources Read InstructionsPOWER-CORD Protection Power LinesDamage Requiring Service Replacement PartsSafety Check Wall or Ceiling MountingHeat NEC SectionFeatures Table of Contents Precautions When YOU Experience the Above ConditionsMoisture Condensation Moisture will Condense on the Unit in the Following CasesPower Source To USE AC Power SourceAC Outlet AC Power Cord Connect to a 120V, 60Hz outlet Power Indicator Lights when the power is turned onLocation of Controls Cassette Loading Slot To insert or remove a video tapeRemote Control MenuPolarity diagram Battery compartmentArrow Paying attention toAntenna Connections MatchingCombiner UHF 300 ohm VHF 300 ohm Indoor Antenna For Subscribers to Basic Cable TV Service For Subscribers to Scrambled Cable TV ServiceCable TV Connections Setting the Language Enter buttonNormal TV viewing Auto Clock Setting Auto Clock SettingAuto Clock Adjustment To SET Auto Clock to OFFPress the Menu button. Press the SET Press the Enter buttonPress the Menu button until the Menu screen is cleared Manual Clock Setting Example Setting the clock to 830 AM, 23rd. MON OctoberTo move cursor backward, press the Cancel button Press the SET/TRACKINGAdjust the volume level by TV OperationTo turn on the TV/VCR VHF/UHF ChannelsMuting Channel +Call Sleep TV/CAPTION/TEXTQuick View What is Closed CAPTIONING? Closed Captioning with a VCRTo View Closed Captions TV/CATV mode Selected modeTo Memorize Channels Automatic Memory Tuning Channels available in your areaScreen is cleared Using SET/TRACKING + or To ADD/DELETE ChannelsOr Channel + or button Setting the V-CHIP To Register PasswordEnter the same password Again for the safety, thenTo SET the V-CHIP Movie Rating is not set All agesPG-13 Parental guidance Less than 13 years old Under 17 years oldTo Change Password To SET the on Timer + or button to setDesired hour, then press the Enter button Set the desired minuteTo SET the OFF Timer Example Turning off the TV at 1130 PMPicture Control Adjustments BrightnessContrast Menu buttonSharpness Cancel Button to adjust the sharpness of the picture Preset levelsColor Tint Press the Enter button until Sharpness appearsAutomatic Power on and Play Loading and Unloading a Video CassetteLoading UnloadingTo Prevent Accidental Erasure To Record Again Tape Speed and Maximum Playback / Recording TimePlayback To Start PlaybackTo Stop Playback To play a prerecorded tapeTo Rewind or Forward the Tape Rapidly Digital Tracki NG ControlFORWARD/REVERSE Picture Search Special Playback To Visually Search for Desired PointsSpeed Search Times Skip Search To Watch Still PictureRepeat mode is canceled To Watch a Tape RepeatedlySelect the Auto Repeat option PositionRecording a TV Program Recording and Viewing the Same TV ProgramScreen and the Rec/Otr indicator will light To Stop Recording To Stop Recording TemporarilyTo be recorded. Example Channel Press the REC/OTR buttonONE-TOUCH Timer Recording OTR TV/VCR channel cannot be changed during recordingTimer Recording Check the Timer REC SET option is selectedThen press the Enter button Select the Program position, then pressTo set the timer for another program, press Indicator will light. The Timer is programmedWhen the programmed time is reached, Recording is automatically startedOther Functions for the Timer Recording To SET DAILY/WEEKLY TimerTo Confirm the Settings ExampleRecording Prog.1 Prog.2 Prog.3 Control Settings Program Deleted PartsUsing the Real Time Tape Counter To View the Counter DisplayTape Counter Counter toUsing Zero Return Duplicating a Video Tape Connection to Another VCRConnection to Camcorder Tion tab intact into the TV/VCRReception Disturbances IgnitionTroubleshooting Guide Symptoms Cause Possible Solutions PowerNo power TV Broadcast ReceptionSymptoms Cause Possible Solutions Remote ControlRecording PlaybackVideo Head Cleaning Snowy PictureSpecifications AccessoriesTelevision VCRMemo Español 545A201A K 00/03