1 Warnings
Warnings
•Read all installation instructions and site survey reports, and verify correct equipment installation before connecting the system to its power source.
•Remove jewelry and watches before installing this equipment.
•Install the equipment in a rack with adequate dimensions and weight allowances.
•Verify the rack is anchored and cannot tip over or break away from its mountings.
•Verify the unit is grounded before connecting it to the power source.
•Verify any device connected to this unit is properly wired and grounded.
•Connect all power cords to a properly wired and grounded electrical circuit.
•Verify the electrical circuits have appropriate overload protection.
•Attach only approved power cords to the device.
•Brocade strongly recommends the use of an Uninterruptible Power Supply (UPS) that supports the Mobility RFS6000 Controller power rating. Not using a UPS can result in data loss or equipment damage due to a power surge or power failure.
•Verify that the power connector and socket are accessible at all times during the operation of the equipment.
•Do not work with power circuits in dimly lit spaces.
•Do not install this equipment or work with its power circuits during thunderstorms or other weather conditions that could cause a power surge.
•Verify there is adequate ventilation around the device, and ambient temperatures meet equipment operation specifications.
•Before installing or handling the Mobility RFS6000 Controller, have on hand an ESD wrist strap or other ESD voltage limiting device.
CAUTION
For safety reasons, the ESD wrist strap should contain a 1 meg ohm series resistor.
2 | Brocade Mobility RFS6000 Controller Installation Guide |
|