Brocade Communications Systems RFS6000 manual Connecting USB devices

Page 27

Connecting USB devices

4

Connecting USB devices

The Mobility RFS6000 Controller contains one USB port for connecting USB flash storage devices to the controller. The controller can use the USB flash storage device for file transfers and firmware updates. Follow the setup instructions below to connect the devices to the controller and then access those devices through the Web UI or Command Line Interface.

1.Connect the USB flash drive to the USB .

2.Wait a few seconds for the drive to be recognized by the controller.

3.Follow the instructions in the Brocade Mobility RFS Controller System Reference Guide or Brocade Mobility RFS Controller CLI Reference for more information on accessing USB storage devices from the controller for file transfers or firmware updates..

NOTE

The controller supports USB flash devices formatted with FAT or VFAT (FAT32) filesystems only. If your flash storage device is formatted with another filesystem you will need to format

Brocade Mobility RFS6000 Controller Installation Guide	19
53-1001573-03

Image 27

Contents Brocade Mobility RFS6000 Controller Brocade Communications Systems, Incorporated Specifications Regulatory Information Supported hardware and software About This DocumentThis chapter AudienceCustomer Support Web Site Contacting BrocadeEmail access Telephone accessDownloads Manuals Warranty coverage Introduction Package contentsBrocade Mobility RFS6000 Controller Installation Guide Site preparation Site preparation Power protection SpecificationsPhysical specifications Power cord specificationsPower cord specifications System status LEDs LED CodesSystem status 1 LED System status 2 LED Event Start up / Post primary system or redundant systemController status redundant system Controller status primary systemFan LED Temperature status LEDRJ-45 Gigabit Ethernet LEDs RJ-45 port speed LEDRJ-45 port status LED SFP Gigabit Ethernet LEDs SFP port speed LEDSFP port activity LED Out of band management port LEDs Out of band management port status LEDOut of band management port speed LED Out of band management port status LED Cabling information Hardware SetupGigabit Ethernet on the Mobility RFS6000 Controller Installing Gigabit Ethernet SFPs Brocade Mobility RFS6000 Controller Installation Guide Connecting USB devices Rack mount instructions Mobility RFS6000 Controller console port setupSupplying power to the Mobility RFS6000 Controller Verifying the installation Regulatory Information Country selectionLaser devices Gigabit Ethernet SFP option Brocade Mobility RFS6000 Controller Installation Guide CE Marking and European Economic Area EEA Class a ITEKorea Waste Electrical and Electronic Equipment Weee Japan power cord statement Chinese CCC statement