Network Settings

5.8Reset Authentication to Factory Defaults

You may reset the Administrator and General User usernames and passwords to the factory defaults.

If you forget your username or password, you may reset them using a serial configuration cable connection (see Section 2.1.1 or 2.2.1 - Connect the Cable), which provides direct access to the card without a username or password. To enter a new username and password, see 5.7 - Change Username / Password.

Table 17 Factory default passwords

Type of User

Factory Default

Description

 

 

 

 

Administrator

Username

Liebert

Full access to configuration and control

Password

Liebert

functions, as well as viewing privileges

 

 

 

 

 

General User

Username

User

Viewing privileges only—no access to

Password

User

configuration or control functions

 

 

 

 

 

Terminal Emulation (Serial or TCP/IP Connection) / Telnet

To reset the usernames and passwords to the factory defaults:

1.Choose IP Network Settings from the Main Menu, then Reset Authentication to Factory Defaults.

Reset authentication to factory Defaults? [y/n] ?>

2.Enter y to reset the Administrator and General User usernames and passwords to the default settings.

NOTE

This feature is not available through the Web interface

27

Page 31
Image 31
Emerson IS-WEB485ADPT installation manual Reset Authentication to Factory Defaults