Emerson IS-WEB485ADPT Install a Liebert IntelliSlot Web Card-Non-Adapter Version, Installation

Installation

2.0 INSTALLATION

! WARNING

Only a qualified service professional should install these products. Liebert recommends having a Liebert Services representative perform the installation in large UPSs. Contact Liebert Services at 1-800-LIEBERT (1-800-543-2378).

2.1Install a Liebert IntelliSlot Web Card—Non-Adapter Version

Follow these steps to install a Liebert IntelliSlot Web card (non-adapter version—P/N IS-WEBCARD, IS-WEBLB and IS-WEBLBDS).

1.Locate the Liebert IntelliSlot option bay on your Liebert equipment—You might need to remove a plastic cover.

2.Insert the Liebert IntelliSlot Web Card into the Liebert IntelliSlot bay.

3.Secure the card with the supplied screws.

4.Connect an Ethernet cable.

DHCP: The card ships with DHCP service enabled. The MAC address is on a sticker on the top of the card.

OR

Static IP: To assign a static IP address or hostname, use terminal emulation software to configure the card, as described in Sections 2.1.1 and 2.1.2.

2.1.1Connect the Cable

1.Locate the blue serial configuration cable (null modem) that shipped with the card.

2.Connect the configuration cable to the DB-9 port on the card and to a COM port on your PC.

2.1.2Prepare the Card for Configuration

•Use terminal emulation software, such as Microsoft® HyperTerminal, to open a connection to the card with the settings in Table 2.

Table 2 Communication settings

Baud Rate:	9600
Data Bits:	8
Parity:	None
Stop Bits:	1
Flow Control:	None

•Press the Enter key for the Main Menu, above right.

•Select IP Network Settings, then Boot/IP Settings and follow the instructions to enter an IP ADDRESS, NETMASK and GATEWAY.

•Press Esc to return to the Main Menu.

•Choose Exit and Save to save your changes and reboot the card.

NOTE

When installing the card in a Liebert NX™, configure the communication port of NX to 2400 baud. See the NX user manual for details.

4