Table A3 Communication settings

Connect to the Card - Terminal Emulation, Telnet or Web Interface

A.2 CONNECT TO THE CARD - TERMINAL EMULATION, TELNET OR WEB INTERFACE

Upgrading the firmware requires connecting to the card with one of these interfaces.

A.2.1 Open the Terminal Emulation Interface - Serial Connection

	To connect to the card using terminal emulation software with a
	serial connection to the Web card:
	1. Open a terminal emulation application, such as	Name
	HyperTerminal.	Name
	HyperTerminal.
	To do this:

•Click the Start button, then Programs, Accessories, Communications and finally HyperTerminal.

2.In the Connection Description window, enter a name for the connection—for example, GXT2U—then click OK.

3.In the Connect To window:

•Choose COM3 from the Connect Using drop-down list.

•Click OK.

4.In the COM3 Properties window, enter the communication settings shown in Table A3.

5.When the message at right appears in the HyperTerminal window, press the Enter key.

COM3

	To connect to the card using terminal emulation software with
	an Ethernet connection to the Web card:
	1. Open a terminal emulation application, such as	Name
	HyperTerminal.	Name
	HyperTerminal.
	To do this:

•Click the Start button, then Programs, Accessories, Communications and finally HyperTerminal.

2.In the Connection Description window, enter a name for the connection—for example, GXT2U—then click OK.

3.In the Connect To window:

•Choose TCP/IP (Winsock) from the Connect Using drop-down list.

•Enter the IP address of the Web card—for example, 192.168.0.125—in the Host Address box, then click OK.

TCP/IP

4.When the message at right appears in the HyperTerminal window, press the Enter key.

5.Enter the Administrator username and password (both are case- sensitive):

a.Login (username—default is Liebert)

b.Password (default is Liebert)

RTCS v2.96.00 Telnet server

Service Port Manager Active <Esc> Ends Session

Password: ********