Emerson IS-WEB485ADPT installation manual Complete the Upgrade and Restore Communication Rate

Updating the Firmware - Xmodem (Serial) Method

Complete the Upgrade and Restore Communication Rate

22.Choose 9600 bps from the menu, shown below left.

23.From the HyperTerminal menu, click on Call, then choose Disconnect (this will not close the HyperTerminal connection to the card).

24.In the HyperTerminal menu bar, click on File, then choose Properties.

25.Click on the Connect To tab and click the Configure button. This opens Port Settings tab in the COM1 Properties window, as shown below right.

26.Choose 9600 from the Bits Per Second drop-down list and click OK, then click OK to close the Properties window.

27.In the HyperTerminal menu bar, click on Call, then choose Call from the drop-down menu.

28.Press the Enter key.

Call menu

9600 bps

Configure button

29.Choose Exit and Save from the Main Menu to reboot the card. When rebooting is complete, the upgrade is finished.

Check the new firmware version if you wish (see A.3.2 - Determine the Liebert IntelliSlot Card Type and Firmware Version).

Main Menu

----------

1:System Information

2:IP Network Settings

3:Messaging

4:Factory Settings

5:Firmware Updates

q:Quit and abort changes

x:Exit and save

Please select a key ?> 5

A12