Brocade Communications Systems manual Supplying power to the Mobility RFS6000 Controller

Page 29

Supplying power to the Mobility RFS6000 Controller

4

2.On the configuration computer, configure a terminal emulation application (such as HyperTerminal) as follows:

Terminal type	VT-100

Port	COM port

Terminal settings	19200bps transfer rate
	8 data bits
	no parity
	1 stop bit
	no flow control
	no hardware compression

Supplying power to the Mobility RFS6000 Controller

Rack mount

bracket

AC inlet

1.Plug an approved AC power cord into the power connector at the back of the Mobility RFS6000 Controller.

2.Plug the cord into a standard AC outlet with a voltage range of 100 to 240 VAC.

Brocade Mobility RFS6000 Controller Installation Guide	21
53-1001573-03

Image 29

Contents Brocade Mobility RFS6000 Controller Brocade Communications Systems, Incorporated Specifications Regulatory Information This chapter About This DocumentAudience Supported hardware and softwareCustomer Support Web Site Contacting BrocadeDownloads Manuals Email accessTelephone access Warranty coverage Introduction Package contentsBrocade Mobility RFS6000 Controller Installation Guide Site preparation Site preparation Physical specifications SpecificationsPower cord specifications Power protectionPower cord specifications System status LEDs LED CodesSystem status 1 LED System status 2 LED Event Start up / Post primary system or redundant systemController status redundant system Controller status primary systemFan LED Temperature status LEDRJ-45 port status LED RJ-45 Gigabit Ethernet LEDsRJ-45 port speed LED SFP port activity LED SFP Gigabit Ethernet LEDsSFP port speed LED Out of band management port speed LED Out of band management port LEDsOut of band management port status LED Out of band management port status LED Cabling information Hardware SetupGigabit Ethernet on the Mobility RFS6000 Controller Installing Gigabit Ethernet SFPs Brocade Mobility RFS6000 Controller Installation Guide Connecting USB devices Rack mount instructions Mobility RFS6000 Controller console port setupSupplying power to the Mobility RFS6000 Controller Verifying the installation Laser devices Gigabit Ethernet SFP option Regulatory InformationCountry selection Brocade Mobility RFS6000 Controller Installation Guide Korea CE Marking and European Economic Area EEAClass a ITE Waste Electrical and Electronic Equipment Weee Japan power cord statement Chinese CCC statement