Brocade Communications Systems RFS6000 manual Site preparation

Page 11

Site preparation

1

Site preparation

•Consult your site survey and network analysis reports to determine specific equipment placement, port capacity, power drops, and so on.

•Assign installation responsibility to the appropriate personnel.

•Identify where all installed components are located.

•Verify appropriate rack mounting requirements.

•Provide a sufficient number of power drops for your equipment.

•Ensure adequate, dust-free ventilation to all installed equipment.

•Identify and prepare Ethernet and console port connections.

•Verify that cable lengths are within the maximum allowable distances for optimal signal transmission.

•Verify that the Mobility RFS6000 Controller is powered through an Uninterruptible Power Supply (UPS).

Brocade Mobility RFS6000 Controller Installation Guide	3
53-1001573-03

Image 11

Contents Brocade Mobility RFS6000 Controller Brocade Communications Systems, Incorporated Specifications Regulatory Information Supported hardware and software About This DocumentThis chapter AudienceCustomer Support Web Site Contacting BrocadeDownloads Manuals Email accessTelephone access Warranty coverage Introduction Package contentsBrocade Mobility RFS6000 Controller Installation Guide Site preparation Site preparation Power protection SpecificationsPhysical specifications Power cord specificationsPower cord specifications System status LEDs LED CodesSystem status 1 LED System status 2 LED Event Start up / Post primary system or redundant systemController status redundant system Controller status primary systemFan LED Temperature status LEDRJ-45 port status LED RJ-45 Gigabit Ethernet LEDsRJ-45 port speed LED SFP port activity LED SFP Gigabit Ethernet LEDsSFP port speed LED Out of band management port speed LED Out of band management port LEDsOut of band management port status LED Out of band management port status LED Cabling information Hardware SetupGigabit Ethernet on the Mobility RFS6000 Controller Installing Gigabit Ethernet SFPs Brocade Mobility RFS6000 Controller Installation Guide Connecting USB devices Rack mount instructions Mobility RFS6000 Controller console port setupSupplying power to the Mobility RFS6000 Controller Verifying the installation Laser devices Gigabit Ethernet SFP option Regulatory InformationCountry selection Brocade Mobility RFS6000 Controller Installation Guide Korea CE Marking and European Economic Area EEAClass a ITE Waste Electrical and Electronic Equipment Weee Japan power cord statement Chinese CCC statement