AMX MAX Servers Mount the Rail/Bracket Assemblies Into the Equipment Rack, Front View Rear View

Rack Mounting MAX Servers

FRONT VIEW REAR VIEW

The bottom of the Adapter Bar sits flush against the tabs on the Rack-Rail assembly

Use these holes to mount the Adapter	Use the outside and center holes to mount
Bar to the Rack-Rails	the Rack-Rail w/ Adapter Bars to
	the equipment rack

FIG. 61 Adapter Bar mounted to the front of the Rack-Rail assembly

2.Attach an Adapter Bar to the rear of each of the two Rack-Rail assemblies (FIG. 62). Once the Adapter Bars have been attached to the front and rear of both Rack-Rail assemblies, the Rack-Rails are ready to use.

Mounting rails on equipment rack

Adapter Bar

(front)

Rail Assembly

Adapter Bar

(rear)

FIG. 62 Mount the Adapter Bars to the Rail assemblies

Step 5: Mount the Rail/Bracket Assemblies Into the Equipment Rack

Once the Extension Brackets (or End Brackets) and Adapter Bars have been attached to the Rail Assemblies, the Rail/Bracket Assemblies are ready to be mounted into the equipment rack.

Install the Rack-Rail assemblies into the equipment rack, aligning the holes on the Adapter Bars to the mounting rails in the rack as shown in FIG. 63:

MAX Servers: HT Home Theater and MMS Multimedia Servers 69