INSTALLER GUIDE
UNO-TS2 Touchscreen Controller Connections
For One UNO-TS2 per Controller
An RNET controller (CAV6.6, CAM6.6) supports one UNO-TS2 and up to five UNO keypads per controller, connected to the UNO System Keypad Ports located on the rear panel.
Caution: 12V Zone triggers on the RNET controller cannot be used with this keypad configuration due to 12V power supply capacity. Use an SA-ZX3 and power supply if triggers are used.
102.5
12V Zone trig- gers cannot be used with this keypad configuration
For 2 to 6 UNO-TS2s per Controller
(One UNO-TS2 per Zone)
Each UNO-TS2 must be connected to an SA-ZX3 Keypad Splitter. The SA-ZX3 is powered by a 1201A 1A power supply and uses an RJ-45 CAT-5 patch cable to connect to the controller’s UNO Keypad Port.
The UNO-TS2 connects to the SA-ZX3 with a CAT-5 110 punchdown on the touchscreen end and an RJ-45 connection on the SA-ZX3 end.
UNO-S1/S2 keypads can share the SA-ZX3 with an UNO-TS2, but they must be configured for the same zone.
