UNO-TS2 Touchscreen Installation, Keypad Installation

Keypad Installation

To install a double-gang keypad, you will need a UL/CSA approved plastic 32ci double-gang electrical box.

Note the minimal clearance around the box for the bezel. This is larger than a typical light switch cover, so additional space may be required.

For best viewing and usage, the UNO-TS2 should be mounted at thermostat height, or about 59” from the floor.

Route CAT-5 wire to the junction box from the con- troller.

Use the supplied 110 punchdown tool to con- nect each wire to its corresponding color labeled on the punchdown terminal.

Mount the keypad in the electrical box and attach the cover plate. Repeat the steps until all keypads are installed.

INSTALLER GUIDE

UNO-TS2 Touchscreen Installation

	Size of UNO-TS2 bezel
	6.0” W x 4.875” H
	Size of standard 2-gang box
	4.0” W x 3.81” H
Width	Size of standard 2-gang wallplate	Width
difference	Size of standard 2-gang wallplate	difference
0.72”	4.56” W x 4.5” H	0.72”
	4.56” W x 4.5” H

UNO-TS2 bezel size vs. standard wallplate

32ci plastic junction box

UNO-TS2 touchscreen

UNO-TS2 Bezel

Touchscreen Bezel Removal

To remove the bezel from the front of an installed touchscreen, you will need a flat screw- driver. Place the screwdriver blade in the slot between the bezel and the molding, located below the “R” on the bottom edge of the bezel. Twist the blade until a loud click is heard; this

sound is the bezel locking tabs releasing from the frame catch. The bezel can now be lifted from the touchscreen

To replace the bezel, center it over the front of the touchscreen and press firmly until the bezel clicks into place.