Toshiba TSD-DR40HD Initial DVR Set Up Procedure, Searching for Australian Free-to-Air TV Channels

Computer System HyperTools Tevion TSD-DR40HD User Guide

3. Initial DVR Set Up Procedure

After all device connections have been accomplished a number of initial setup procedures will need to be performed. Areas shaded in grey may or may not be needed as part of the procedure (they are mostly to do with our particular procedures for powering devices up or down).

3.1 Searching for Australian Free-to-Air TV Channels

Since we are (in Australia) still using analogue TV signals, the available channels need to be configured:

1.On TRC press Power button to turn on the TV (if not already on).

2.On TRC press button until 2 is shown.

3.On DRC press STANDBY/ON button to turn on the DVR and wait until “No disc” message is shown.

4.On DRC press SETUP button to enter “Setup” menus and display the “Setup Menu – Recording”.

5.On DRC press Right Arrow button to actually enter “Setup Menu – Recording”.

6.On DRC press Down Arrow button to “Auto Scan Channel” option and press SELECT button.

7.On DRC if prompted to confirm the action just press SELECT button.

8.On DRC in “Scan Channels” screen press SELECT button leaving “Tuner input source” set to “Air”.

9.On DRC press SELECT button to start a search for Analogue TV Channels.

10.The actual scanning will take a minute or two and will probably find six Fre-to-Air TV channels. Each channel found is identified by a program number (Pxxx) and a channel number (CHzzz).

11.On DRC press Down Arrow button to “Program Table”. Then press SELECT button to enter the “Sort” screen where the list of program numbers and channel names will be visible. The list is as follows:

P003 CH002 (should be renamed ABC01)

P009 CH007

P011 CH009

P013 CH010

P025 CH028 (should be renamed SBS28)

P028 CH031

12.On DRC press Down Arrow button to get to P003 CH002 then press the SELECT button to enter the “Modify channel information” screen.

13.On DRC press Down Arrow button to move down to the Name field and change it one character at a time to the desired name (e.g. CH002 changed to ABC01) and leaving all other settings as they are.

14.Repeat Steps 11-13 renaming CH028 to SBS28.

15.On DRC press SETUP button to exit “Setup” menus.

F:\Our Files\Our Computers\User Guides\Tevion (Wintal)\Tevion TSD-DR40HD DVR User Guide.doc 18/9/08 at 21:49 Page 7