Sharp HT-DV50H, HT-DV40H Setting the clock Remote Control only, Press the CLOCK/TIMER button

Setting the clock (Remote Control only)

HT-DV40H HT-DV50H

1 2 3

4 5 6

7 8 9

0 +10

In this example, the clock is set for the 24-hour (0:00) display.

1Press the ON/STAND-BY button to turn the power on.

2Press the CLOCK/TIMER button.

3Within 10 seconds, press the or button to select “CLOCK”, and press the MEMORY/DIMMER button.

4Press the or button to select 24-hour or 12-hour display and then press the MEMORY/DIMMER button.

“0:00”		The 24-hour display will appear.
	(0:00 - 23:59)
“AM 12:00”		The 12-hour display will appear.
		(AM 12:00 - PM 11:59)
“AM 0:00”		The 12-hour display will appear.
		(AM 0:00 - PM 11:59)

5Press the or button to adjust the hour and then press the MEMORY/DIMMER button.

Press the or button once to advance the time by 1 hour. Hold it down to advance continuously.

6Press the or button to adjust the minutes and then press the MEMORY/DIMMER button.

Press the or button once to advance the time by 1 minute. Hold it down to change the time in 5-minute intervals.

To confirm the time display:

[When the unit is in the stand-by mode] Press the CLOCK/TIMER button.

The time display will appear for about 10 seconds.

[When the power is on]

Press the CLOCK/TIMER button.

Within 10 seconds, press the or button to display the time. The time display will appear for about 10 seconds.

Note:

The “CLOCK” will appear or time will flash to confirm the time display when the AC power supply is restored after a power failure or unplugging the unit. If incorrect, readjust the clock as follows.

To readjust the clock:

Perform “Setting the clock” from step 1. If the “CLOCK” does not appear in step 3, step 4 (for selecting the 24-hour or 12-hour display) will be skipped.

To change the 24-hour or 12-hour display:

1Clear all the programmed contents. [Refer to “Factory reset, clearing all memory” on page 64 for details.]

2Perform “Setting the clock” from step 1.

Basic Operation

31