Sharp HT-DV40H System connections continued, CP-DV40H, Driving screws, Preparation for Use

HT-DV40H HT-DV50H

System connections (continued)

Make sure to leave the AC power lead disconnected when connecting the speakers.

To prevent accidental short circuits between + and - terminals, connect the speaker wires to the speakers first, then to the unit.

Preparation for Use

CP-DV40H

To install the speaker stand

1Align the hole on the speaker stand to the hole on speaker. Fix them securely with the special screw provided.

Speaker

Speaker stand

Special screw

2Route the speaker wire through the speaker stand hole. Connect the wire without insulation tube to the speaker minus (-) terminal, and the wire with red insulation tube to the speaker plus (+) terminal.

Stand hole

3Connect the other end to the main unit.

4Attach the stand cover.

Stand cover

Special screw

To mount the speakers on the wall

Caution:

Be very careful to prevent the speaker [2.1kg (4.6 lbs.)] from falling when mounting on the wall.

Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The speakers may fall.) If unsure, consult a qualified service technician.

Mounting screws are not supplied. Use appropriate ones.

Check all mounting screws for looseness and that they are engaged in the speakers.

Mount the speakers on the wall using 2 screws each for horizontal position and using 1 screw each for vertical position.

Select a good location. If not, accidents may occur or the speaker may get damaged.

Avoid placing on a bed, sofa, water tank, sink and hallway wall. To avoid accidents, fix the speaker wires to the wall. You may trip over them.

SHARP is not responsible for accidents resulting from improper installation.

Driving screws

SHARP designed the speakers so you may hang them on the wall. Use proper screws (not supplied). See below for size and type.

3.2 mm (1/8")

5 mm (3/16")

9 mm (3/8")

Min. 22 mm (7/8")

16