Sharp HT-DV50H Subwoofer, Aerial connection, External FM aerial, AC power connection, each other

Subwoofer

1Connect the wire without insulation tube to the SUBWOOFER minus (-) terminal, and the wire with purple insulation tube to the SUBWOOFER plus (+) terminal.

Purple

Caution:

Never mistake the FRONT SPEAKERS and the SUBWOOFER terminals. The unit or the speakers may be damaged.

If you use other speakers with an impedance lower than that specified, the unit may be damaged. Front speakers: 4 ohms, Subwoofer: 12 ohms.

Do not mistake the right and the left
channels. The right speaker is the one on
the right side when you face the unit.
Do not let the bare speaker wires touch
each other.
Do not allow any objects to fall into or to be
placed in the bass reflex duct.
Do not stand or sit on the subwoofer/
speakers. You may be injured.	Incorrect

Aerial connection

Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS	FM
socket and position the FM aerial wire in the
	aerial
direction where the strongest signal can be
received.
Note:
Placing the aerial on the unit or near the AC
power lead may cause noise pickup.
Place the aerial away from the unit for better
reception.

External FM aerial

Use an external FM aerial if you require better reception. Consult your dealer.

75 ohms	External
coaxial cable	FM aerial

Note:

When an external FM aerial is used, disconnect the supplied FM aerial wire.

AC power connection

After checking all the connections have been made correctly, plug the AC power lead of this unit into the wall socket. If you plug in the unit first, the unit will enter the stand-by mode.

Wall socket

(AC 220 - 240 V ~ 50 Hz)

Note:

Unplug the AC power lead from the wall socket if the unit will not be in use for a prolonged period of time.

Demonstration mode

The first time the unit is plugged in, the unit will enter the demonstration mode. You will see words scroll.

To cancel the demonstration mode:

When the unit is in the power stand-by mode (demonstration mode), press the SHIFT and DEMO buttons on the remote control. The unit will enter the low power consumption mode.

To return to the demonstration mode:

When the unit is in the power stand-by mode, press the SHIFT and DEMO buttons on the remote control again.

HT-DV40H HT-DV50H

Preparation for Use

19