Fahrenheit to Celsius
The oven has been preset to a Fahrenheit temperature. To change to Celsius, follow these steps:
I.Turn off ovens.
2.Touch and hold the START pad and then the CONVECTION pad
at the same time for 3 seconds.
3.“F” appears in the temperature digits; release both pads at the same time.
4.Touch CONVECTION; “C” replaces “F.” This alternates when CONVECTION is touched.
5.To complete the change, touch START.
Voltage Change Option
The oven has been preset for 240 VAC. If your residence has been supplied with 208 VAC, the oven voltage can be changed during installation.
1.Turn both ovens off. Touch OVEN OFF for each oven.
2.Touch and hold the START pad and the SELF CLEAN pad at the same time for 3 seconds.
3.“240” appears in the display. Release both pads at the same time.
4.Touch the SELF CLEAN pad. “240” is replaced with “208.” This alternates when SELF CLEAN is touched.
5.To complete the change, touch START.
Calibrating Oven Temperature
The electronic thermostat has been preset to 0°F and accurately maintains its setting. If the browning results are too light or too dark for your preferences, you can raise or lower the setting.
To change calibration of oven temperature for single or upper ovens:
1.Turn off oven(s).
2.For single oven or upper oven, touch and hold the START pad and then touch the BAKE pad.
3.“0” (zero) appears in the temperature digits; release all pads at the same time.
4.Touch BAKE and 0 changes in increments of 5 degrees each time it is touched. The maximum adjustment is ± 35ºF.
5.To complete the change, touch START.
To change calibration of oven temperature for lower oven on double ovens:
1.Touch the ROAST pad.
2.Continue with Steps 3 through 5, as described above.
NOTE: The available temperature range for this oven is 100ºF to 550ºF. This applies to all conventional cooking modes. A change in the calibration does not affect Dehydrate, Proof or Warm modes.
Beep Volume
The volume of the beeps can be adjusted. Touch and hold the START pad followed by the PROBE pad for three seconds. Touch PROBE pad again to increase or decrease volume, from levels 1 to 3. Touch START to set volume selection.
How to Obtain Service
For authorized service or parts information, phone (800)
We want you to remain a satisfied customer. If a problem occurs that cannot be resolved to your satisfaction write to Thermador Customer Support Center,
5551 McFadden Avenue, Huntington Beach CA, 92649 or call:
Please include the Model Number, Serial Number, Fabrication Date and Date of Original Purchase and Installation.
54