Timers - Digital and Analogue, Conditional
Access
Programme Timers - Digital Only
This feature will set the television to go to a specific channel at a certain time. It can be used to view a particular programme, or by setting the mode to daily or weekly, can be used to view a series of programmes.
•Press MENU and Up or Down to select Timers item menu and press OK to continue.
•To add a timer, press the YELLOW button on the remote control. Then Add Timer window appears.
Channel: Left or Right keys will navigate the user through the TV or Radio list.
Date: Starting date is entered via the Left/Right or the numeric buttons.
Start: Starting time is entered via the Left/Right or the numeric buttons.
End: Ending time is entered via the Left/Right or the numeric buttons.
Change/Delete: permits or prohibits any modifications for other users.
Duration: Duration between Start and End time.
Repeat: You can set a timer to be repeated as Once, Daily or Weekly.
•You can save the adjustments by pressing the GREEN key or cancel the process by pressing the RED button.
•You can edit the list via GREEN key and delete with the RED button.
Sleep Timer - Analogue
The television can be set to turn itself Off after a certain length of time.
•When displaying analogue TV menu, use Left or Right button to select FEATURE menu.
•Press Up or Down button to select Sleep Timer.
• Use Left or Right button to set the desired time.
The timer can be programmed between Off and 120 minutes in steps of 10 minutes.
If Sleep Timer is activated, at the end of the selected time, the TV goes automatically to standby mode
Conditional Access
The Common Interface Slot, situated on the side of the television, enables the insertion of a CAM (Conditional Access Module) and card. These are purchased from a service provider and allow additional subscription broadcasts to be viewed. For more information, see a service provider.
•Insert the CAM and card into the Common Interface Slot, following the instructions provided with the CAM.
•Press the MENU button to display the main menu and use the “
” or “
” button to highlight the Conditional Access line and press the OK button:
Important:
•Switch off the TV and unplug from the mains.
•The CAM should be correctly inserted, it is impossible to insert fully if reversed. The CAM or the TV terminal may be damaged if the CAM is forcefully inserted.
•Connect the TV to the mains supply, switch on and then wait for few moments until the card is activated.
•Some CAMs may require the following set up. Please set the CAM by entering the IDTV menu, Conditional Access then pressing the “OK” button. (CAM set up menu is not displayed when it is not required.)
•To see the viewing contract information: enter IDTV; press the “MENU” button, then highlight Conditional Access and press the “OK” button.
•When no module is inserted, “No Conditional Access module detected” message appears on the screen.
•Refer to the module instruction manual for details of the settings.
Note: Insert or remove the CI module only when the TV is switched off or in standby mode.
English - 25 -
00_MB45M_[GB]_3910UK_IDTV_SILVER8_32740W_(IB_INTERNET)_ | 10068433.indd 25 | 30.03.2011 14:31:37 |
|
|
|