Toshiba 42hl167 manual Displaying TV status information, Understanding the auto power off feature

Chapter 6: Using the TV’s features

Displaying TV status information

To display TV status information using RECALL:

Press Eon the remote control.

The following information will display (if applicable):

•Current input (ANT, VIDEO 1, etc.)

•If ANT is the current input, either “CABLE” (for cable TV) or “ANT” (for over-the-air broadcasts).

•Channel number (if in ANT mode)

•Channel label (if set)

•Digital signal strength indicator (bar graph in lower right corner of box; for ATSC signal only)

•Stereo, Mono or SAP audio status (when HDMI input mode, Dolby Digital or PCM)

•Video resolution

•Aspect ratio of incoming video signal (4:3 or 16:9)

•V-Chip rating status

•GameTimer (if set)

ANT	Stereo SAP 1080i 16:9 TV-PG L V
123-456	9:00pm .
ABCHD

To close the RECALL screen:

Press Eagain.

To display TV status information using INFO:

Press Qon the remote control.

The following additional information will display for off air digital channels (if applicable):

•Title

•Duration

•Detailed description

ANT	Stereo SAP 1080i 16:9	TV-PG L V
123-456	,	East 9:00pm -11:00pm
ABCHD	MLB Young s XXX...
	,
	Today s Major League Baseball.

Note: The location of the banner can be moved to the top or bottom of the screen by pressing B or b while the RECALL or INFO display is on-screen. (The last position will be stored to memory.)

Understanding the auto power off feature

The TV will automatically turn itself off after approximately 15 minutes if it is tuned to a vacant channel or a station that completes its broadcast for the day. This feature functions in ANT mode only.

Understanding the last mode memory feature

If the power is cut off while you are viewing the TV, the Last Mode Memory feature automatically turns on the TV when the power is resupplied.

Note: You should unplug the TV’s power cord if it is possible that you will be away from the TV for an extended period of time after the power is restored.

66