Toshiba 42hl167 manual Appendix, Specifications, Format Resolution Frequency Pixel Clock Frequency

Page 75

Chapter 9: Appendix

Specifications

Note:

This model complies with the specifications listed below.

Designs and specifications are subject to change without notice.

This model may not be compatible with features and/or specifications that may be added in the future.

Television System

NTSC standard

ATSC standard (8VSB)

Digital Cable (64 QAM, 256 QAM; in-the-clear, unencrypted)

Channel Coverage

VHF: 2 through 13

UHF: 14 through 69

Cable TV: Mid band (A-8 through A-1, A through I) Super band (J through W)

Hyper band (AA through ZZ, AAA, BBB) Ultra band (65 through 94, 100 through 135)

Power Source: 120 V AC, 60 Hz

Power Consumption

42HL167: 169 W (average)

0.6W in standby mode

47HL167: 194 W (average)

0.3W in standby mode

52HL167: 219W (average)

0.4W in standby mode

Audio Power: 10 W + 10 W

Speaker Type

42HL167/47HL167:

Main: Four 2-3/8 × 4-3/4 inches (60 × 120 mm)

Tweeter: Two 1-1/4 inches (33 mm) round

52HL167: Two 4 inches (100 mm) round

Video/Audio Terminals

S-VIDEO INPUT:

Y:1 V(p-p), 75 ohm, negative sync.

C:0.286 V(p-p) (burst signal), 75 ohm

VIDEO/AUDIO INPUT:

VIDEO: 1 V(p-p), 75 ohm, negative sync.

AUDIO: 150 mV(rms) (30% modulation equivalent, 22 k ohm or greater)

HDMI input supports the following signal formats:

ColorStream® (component video) HD INPUT: VIDEO:Y: 1V(p-p), 75 ohm

PR: 0.7 V(p-p), 75 ohm

PB: 0.7 V(p-p), 75 ohm

Suggested formats: 1080i, 720p, 480p, 480i AUDIO: 150 mV(rms), 22 k ohm or greater

HDMI™ INPUT:

HDMI compliant (type A connector) HDCP compliant

Audio Lip Sync supported Suggested formats: See table below.

HDMI Audio: 2-channel Linear-PCM; 32/44.1/48 kHz sampling frequency; 16/20/24 bits per sample

FIXED AUDIO OUTPUT:

150 mv (rms) (30% modulation equivalent, 2.2 k ohm or less)

DIGITAL AUDIO OUTPUT:

Optical type

IR OUT:

3 V(p-p), 3.5 mm mono socket

PC INPUT:

15-Pin D-sub Analog RGB

Dimensions

42HL167: Width: 41-1/8 inches (1,042 mm) Height: 30 inches (762 mm) Depth: 13-7/8 inches (352 mm)

47HL167: Width: 44-5/8 inches (1,132 mm) Height: 31-3/8 inches (795 mm) Depth: 13-7/8 inches (352 mm)

52HL167: Width: 50-1/2 inches (1,280 mm) Height: 33-3/8 inches (847 mm) Depth: 15-3/8 inches (390 mm)

Mass (weight)

42HL167: 71.5 lbs (32.4 kg)

47HL167: 86.9 lbs (39.4 kg)

52HL167: 101.6 lbs (46.1 kg)

Operating conditions

Temperature: 32ºF - 95ºF (0ºC - 35ºC)

Humidity: 20 - 80% (no moisture condensation)

Supplied Accessories

Remote control with two size “AA” alkaline batteries

Owner’s manual (this book)

Lead clip

Use this clip to attach the TV to a wall, pillar, or other immovable structure. See item 20 on page 3.

Format

Resolution

V. Frequency

H. Frequency

Pixel Clock Frequency

VGA

640 x 480p

59.940/60Hz

31.469/31.500kHz

25.175/25.200MHz

 

 

 

 

 

480i

720 x 480i

59.940/60Hz

15.734/15.750kHz

27.000/27.027MHz

 

 

 

 

 

480p

720 x 480p

59.940/60Hz

31.469/31.500kHz

27.000/27.027MHz

 

 

 

 

 

720p

720 x 480p

59.940/60Hz

44.955/45.000kHz

74.176/74.250MHz

 

 

 

 

 

 

1080i

1920

× 1080i

59.940/60Hs

33.716/33.750kHz

74.176/74.250MHz

 

 

 

 

 

 

1080p

1920

× 1080p

23.976/24Hz

26.973/27.000kHz

74.176/74.250MHz

 

 

 

 

 

 

1080p

1920

× 1080p

59.940/60Hz

67.433/67.500kHz

148.352/148.500MHz

 

 

 

 

 

 

75

Image 75
Contents 42HL167 47HL167 52HL167 Dear Customer Safety PrecautionsInstallation Important Safety InstructionsInstallation, Care, and Service Additional Safety PrecautionsCare ServiceRemoving the Pedestal Stand To Display your LCD TV using a Wall BracketChoosing a location for your LCD TV To Display your LCD TV on the included Pedestal StandPart Important notes about your LCD TVTrademark Information Contents Troubleshooting Features of your new TV IntroductionWelcome to Toshiba Introduction TV front and side panel controls and connections Green and Yellow LEDsHD1, ColorStream HD2, Hdmi 1, Hdmi 2, Hdmi 3, PC ColorStream HD-1 and ColorStream HD-2 TV back panel connectionsConnecting your TV Overview of cable typesAbout the connection illustrations To view the VCR Connecting a VCR and antenna or Cable TV no Cable boxTo view the antenna or Cable signal You will needStandard audio cables Connecting a VCR with S-video and a cable boxTo view basic and premium Cable channels Coaxial cables Video cableTo record a TV program while watching a DVD To view antenna or Cable channelsTo view the DVD player To view the VCR or view and record antenna channelsTo connect the IR blaster cable To control the devicesIf you cannot locate the device’s infrared sensor Connecting a camcorder To view the camcorder videoSelect the Video 2 video input source on the TV To connect a DVI device, you will need Connecting an Hdmi or DVI device to the Hdmi inputTo connect an Hdmi device, you will need To view the Hdmi device videoCE-Link connection Before controlling the devicesThree Hdmi cables To control the audio Connecting an audio systemConnecting a personal computer PC To connect a PC to the PC in terminal on the TVTo connect a PC to the Hdmi terminal on the TV To install the remote control batteries Using the remote controlInstalling the remote control batteries Remote control effective rangeTheaterWide 1/2/3, Full, 43 HD, and Native Learning about the remote controlRemote Control functional key chart Combo ReceiverSatellite DVD CH RTN Mode Select Device mode control after programming Using the remote control to operate your other devicesDevice code setup Mode Select Default device mode control before programmingTo reset the remote control Using the volume lock featureOperational feature reset To unlock the remote control’s volume keysTVs Cable boxesSatellite receivers 3D LAB DVDsVCRs DVD/VCR ComboKEC STS Audio Amp PVRsCable/PVR Combo DBS/PVR ComboSAE Audio Amp/TunersMenu layout and navigation Main menu layoutIcon Option Thinc menu Setup/Installation menu layoutSetup menu InstallationVideo Navigating the menu systemSelecting the menu language Setting up your TVConfiguring the antenna input source for the ANT terminal To configure the ANT input sourceTo add or delete channels in the channel memory Programming channels automaticallyManually adding and deleting channels in the channel memory To program channels automaticallySetting the Auto Input feature To assign channel labels To reset Auto InputLabeling channels To turn off the Auto InputTo delete the custom label Setting the Hdmi audio modeTo set the Hdmi audio mode To remove channel labelsViewing the digital signal meter Reset Factory DefaultsViewing the system status Highlight No and press T Selecting the Power-On ModeTo cancel the reset To set the Power-On Mode featurePress CABLE/SAT, DVD, or VCR/PVR Using the TV’s featuresLabeling the video input sources To label the video input sourcesTuning channels Tuning channels using Channel BrowserFavorites Browser Adding and clearing channels and inputs in the History List Elements of the Channel BrowserTuning to a specific channel programmed or unprogrammed Switching between two channels using Channel ReturnSwitching between two channels using SurfLock TheaterWide 2 picture size for letter box programs Selecting the picture sizeNatural picture size TheaterWide 1 picture size for 43 format programsFull picture size for 169 480i, 480p source programs only To set the scroll settingsUsing the Freeze feature Adjusting the picture Selecting the picture modeAdjusting the picture quality To view captions or text Using the closed caption modeDigital CC Settings Base closed captionsCC Selector Adjusting the audioUsing the Closed Caption button on the remote control Using the digital audio selectorMTS field, select Stereo Press C or c to adjust the levelSelecting stereo/SAP broadcasts To listen to stereo soundUsing the Dolby Digital Dynamic Range Control feature Using the StableSound featureChanging your PIN code Using the Locks menuEntering the PIN code If you cannot remember your PIN codeTo download the additional rating system if available Press b to highlight Enable Rating BlockingBlocking TV programs and movies by rating V-Chip To block and unblock TV programs and moviesBlocking channels To block channelsTo unblock individual channels Unlocking programs temporarily Using the input lock featureUsing the control panel lock feature Using the GameTimerTo set the PC Audio Using the PC settings featureSetting the PC Audio To adjust the PC settingsSetting the sleep timer Using CE-LinkCE-Link playback device HD DVD player, etc. control Volume and Mute controls of Audio Receiver To set the CE-Link SetupOther CE-Link functions Understanding the auto power off feature Understanding the last mode memory featureDisplaying TV status information Using the static gamma feature Using the TV’s advanced featuresUsing the advanced picture settings features Using dynamic contrastTo change the CableClear settings Selecting the color temperatureUsing CableClear digital noise reduction To select the color temperatureUsing Mpeg noise reduction Using the ColorMaster featureUsing Color Palette Adjustment To turn off Game Mode Using the Game Mode featureTo reset ColorMaster to its factory settings To turn on Game ModeHighlight Advanced Audio Settings and press T Using the advanced audio settings featuresUsing the SRS WOW surround sound feature To adjust the WOW settingsGeneral troubleshooting TroubleshootingNo CE-Link operation Channel tuning problemsClosed caption problems Rating blocking V-Chip problemsLED indications LED Indication Condition SolutionSpecifications Format Resolution Frequency Pixel Clock FrequencyAppendix For LCD Televisions 26 and Larger Limited United States WarrantyFor Toshiba Brand Flat Panel Televisions Limited Canadian WarrantyDisclaimer and Limitation of Remedy Appendix Freeze IndexPage 07-05
Related manuals
Manual 82 pages 12.32 Kb Manual 82 pages 16.07 Kb