Toshiba 55SL417U Displaying TV status information, Volume and Mute controls of Audio Receiver

Chapter 6: Using the TV’s features

VOLUME and MUTE controls of Audio Receiver

With your TV’s remote control, you can adjust or mute the sound volume of the Audio Receiver.

• adjust the volume level.

• turns off the sound.

Note:

••To use this function:

−−Set Speaker Preference to Audio Receiver in the REGZA-LINK Setup menu.

−−Confirm that a connected REGZA-LINK®device (such as DVD player, etc) is selected for the Audio Receiver input source.

••You can also use this function when the audio receiver is connected to the TV’s DIGITAL AUDIO OUT terminal (not HDMI connection). In this case, select a digital audio input mode on the Audio Receiver.

••These functions depend on the device connected.

Other REGZA-LINK®functions

When the Enable REGZA-LINKand each item in the REGZA-LINK Setup menu are set to On, the following functions will be enabled.

Item	Description
	If a connected HDMI device starts
TV Auto	playing video or audio, the TV will
Input Switch	automatically switch to the appropriate
	HDMI input.
TV Auto	If a REGZA-LINK®device is turned
Power	on, the TV turns on automatically.
Device Auto	If the TV is turned off the TV will send
	a message to turn off all of the REGZA-
Standby
	LINK® devices connected to the TV.
	From this item, you can set your audio
	output preference to the TV speakers
	or the audio receiver speakers. When
Speaker	this item is set to Audio Receiver,
	the TV remote can be used to adjust
Preference
	or mute the volume of the audio.
	This item will be grayed out unless
	a REGZA-LINK®compatible audio
	receiver is connected.

Note: When you turn on the Audio Receiver, change its input source, or adjust the sound volume, the sound will be output from the audio receiver’s speakers even if TV Speakers has been selected. Turn the TV off and on again to output the sound from the TV speakers.

To set the REGZA-LINK®Setup:

1無 From the Setup menu, highlight REGZA-LINK Setup and press .

2無 Press p or q to highlight Enable REGZA-LINK. 3無 Press t or u to select On.

Note: If you select Enable REGZA-LINK Off, the other items will be grayed out.

4無 Press p or q to highlight the REGZA-LINK Setup item you want to use, and press t or u to select On or desired mode.

•TV Auto Input Switch: On/Off

•TV Auto Power: On/Off

•Device Auto Standby: On/Off

•Speaker Preference: TV Speakers/Audio Receiver

5無 To save the new settings, highlight Done and press

. To revert to the factory defaults, highlight Reset and press .

Displaying TV status information

To display TV status information using RECALL:

Press RECALL on the remote control.

The following information will display (if applicable):

•Current input (ANT/CABLE, VIDEO, etc.)

•If ANT/CABLE is the current input, either “CABLE” (for cable TV) or “ANT” (for over-the-air broadcasts).

•Channel number (if in ANT/CABLE mode)

•Digital signal strength indicator (bar graph in lower right corner of box; for ATSC signal only)

•Stereo, Mono or SAP audio status (when HDMI input mode, Dolby Digital or PCM)

•Video resolution

•Aspect ratio of incoming video signal (4:3 or 16:9)

•V-Chip rating status

•GameTimer (if set)

(continued)

49