Toshiba 55SL417U, 55SL412U, 46SL412U, 40SL412U Choosing a location for your LCD TV, Service

Page 5

cord and disconnect the antenna from the TV if you leave the TV unattended or unused for long periods of time.

40)ALWAYS unplug the TV to completely disconnect from mains power. When the TV is turned off using the on/off switch, it is not completely disconnected from power and a minute amount of current is still consumed.

41)During normal use, the TV may make occasional snapping or popping sounds. This is normal, especially when the unit is being turned on or off. If these sounds become frequent or continuous, unplug the power cord and contact a Toshiba Authorized Service Provider.

42)DANGER: RISK OF SERIOUS PERSONAL INJURY OR DEATH!

Never strike the screen with a sharp or heavy object.

43)• The LCD screen of this product can be damaged by ultraviolet radiation from the sun. When selecting a location for the television, avoid locations where the screen may be exposed to direct sunlight, such as in front of a window.

Never touch, press, or place anything on the LCD screen. These actions will damage the LCD screen. If you need to clean the LCD screen, follow the instructions in item 35 on page 4.

Service

44)WARNING:

RISK OF ELECTRIC SHOCK!

Never attempt to service the TV yourself. Opening and removing the covers may expose you to dangerous voltage or other hazards. Failure to follow this WARNING may result in death or serious injury. Refer all servicing not specified in this manual to a Toshiba Authorized Service Provider.

45)If you have the TV serviced:

Ask the service technician to use only replacement parts specified by the manufacturer.

Upon completion of service, ask the service technician to perform routine safety checks to determine that the TV is in safe operating condition.

Choosing a location for your LCD TV

To Display your LCD TV on the included Pedestal Stand:

Observe the following safety precautions:

1)Read and Follow the pedestal assembly instructions included with the pedestal.

CAUTION: Before beginning pedestal assembly, carefully lay the front of the LCD Panel face down on a flat, cushioned surface such as a quilt or blanket. Leave the bottom of the unit protruding over the edge of the surface and assemble the pedestal as indicated below.

Note: Extreme care should always be used when attaching the pedestal stand to avoid damage to the LCD panel.

2)Place the TV on a sturdy, level surface that can support the weight of the TV.

3)Be sure to secure the TV to a wall, pillar, surface, or other immovable structure (item 25, page 4).

To Display your LCD TV using a Wall Bracket:

If you decide to wall mount your LCD TV, always use a UL listed wall bracket appropriate for the size and weight of the LCD TV (page 2):

1)CAUTION: Two people are required for installation.

2)Unplug and remove any cables and/or other component connectors from the rear of the TV.

3)Remove the screws of the VESA Mounting Pattern show in the next page.

CAUTION: Do not use the screws removed from the back cover to attach the wall mount bracket to the TV.

4)Always use the screws supplied or recommended by the wall mount manufacturer.

5)Follow the instructions provided with your wall bracket. Before proceeding, make sure the appropriate bracket(s) are attached to the wall and the back of the TV as described in the instructions provided with the wall bracket.

6)After attaching the appropriate bracket(s) to the wall and the back of the TV, remove the pedestal stand from the TV as described on the following page 6.

5

Image 5
Contents 40SL412U 46SL412U 55SL412U 55S41U Dear Customer Safety PrecautionsAdditional Safety Precautions Important Safety InstructionsInstallation, Care, and Service InstallationRisk of Electric Shock CareTo Display your LCD TV using a Wall Bracket ServiceChoosing a location for your LCD TV To Display your LCD TV on the included Pedestal StandRemoving the Pedestal Stand TV Size Hole PatternHxV40 TV 46 TVImportant notes about your Energy Star User InformationTrademark Information Contents 1080p output resolution Features of your new TVIntroduction CableClear digital picture noise reduction Page TV top TV front and side panel controls and connectionsLeft side panel TV back panel connections Power CordAbout the connection illustrations Connecting your TVOverview of cable types Connecting a VCR and antenna, Cable TV or Camcorder To view the DVD player To view antenna or Cable channelsTo view the VCR or view and record antenna channels To record a TV program while watching a DVDTo view the Hdmi device video To connect an Hdmi device, you will needTo connect a DVI device, you will need One HDMI-to-DVI adapter cableBefore controlling the devices REGZA-LINKconnectionHdmi cables  TV back panel Audio receiverConnecting a digital audio system Connecting an audio systemTo control the audio Sound menuSignal names for mini D-sub 15-pin connector Connecting a personal computer PCTo connect a PC to the Hdmi terminal on the TV Ground ReservedRemote control effective range Using the remote controlInstalling the remote control batteries 9無 Recall displays TV status information  Learning about the remote control13無 VOL + adjusts the volume level Icon Option Menu layout and navigationMain menu layout Navigating the menu system Setup/Installation menu layoutInitial Setup Setting up your TVTo configure the ANT/CABLE input source Selecting the menu languageProgramming channels into the TV’s channel memory Setting channel skipProgramming channels automatically To program channels automaticallySetting the Hdmi audio mode Setting the time zone Viewing the digital signal meterReset Factory Defaults Viewing the system statusSelecting the video input source to view Using the TV’s featuresLabeling the video input sources To select the video input source to viewFavorites Browser Tuning channelsTuning channels using Channel Browser Adding and clearing channels and inputs in the History List Elements of the Channel BrowserSwitching between two channels using Channel Return Setting the Channel Tuning ModeTuning to the next programmed channel For 1080i, 1080p and 720p signal program source Switching between two channels using SurfLockSelecting the picture size Full For 169 480i, 480p source programs onlyTheaterWide For letter box programs with subtitles TheaterWide For letter box programsNative NormalAdjusting the picture Using the Freeze featureUsing the auto aspect ratio feature Selecting the picture modeBase closed captions Using the closed caption modeAdjusting the picture quality CC Selector Digital CC SettingsTo customize the closed captions To select closed captionsUsing the digital audio selector Adjusting the audioAdjusting the audio quality Muting the soundUsing the Dolby Digital Dynamic Range Control feature Using the Locks menuSelecting the optical audio output format Entering the PIN codeBlocking TV programs and movies by rating V-Chip Changing your PIN codeTo block and unblock TV programs and movies To download the additional rating system if available5無 Press  to select On Blocking TV programs by Canada ratingNot intended for anyone 17 Canadian Rating Menu will appearUsing the GameTimer Using the input lock featureUnlocking programs temporarily Locking channelsUsing the panel lock feature Using the PC settings featureTo adjust the PC settings To lock the panelUsing the Media Player Setting the PC AudioUsing the Media Player with USB To select the Auto Start functionSingle View Viewing photo filesSlideshow Playing music filesDuring playback To set the repeat modeTo close the Music Player 3無 Press  or  to select Off, All or 4無 PressNo Signal Power Down Setting the sleep timerAutomatic Power Down Available remote control key functions Using REGZA-LINKREGZA-LINKplayback device DVD player, etc. control REGZA-LINKinput source selectionTo set the REGZA-LINKSetup Volume and Mute controls of Audio ReceiverTo display TV status information using Recall Displaying TV status informationTo display TV status information using Info Understanding the last mode memory featureTo close the screen Press againUsing the advanced picture settings features Using the TV’s advanced featuresUsing Dynamic Contrast Using the static gamma featureUsing CableClear digital noise reduction Selecting the cinema modeTo change the CableClear settings To turn on Film StabilizationUsing the Game Mode feature Using Mpeg noise reductionTo turn on Game Mode To turn off Game ModeGeneral troubleshooting TroubleshootingRemote control problems Sound problemsChannel tuning problems Closed caption problemsAppendix SpecificationsPC in signal formats Acceptable signal formats for PC in and Hdmi terminalsHdmi signal formats Format Resolution Frequency Pixel Clock FrequencyHow to Obtain Warranty Service Limited United States Warranty for LCD TelevisionsRental Units Your ResponsibilityLimited One 1 Year Warranty on Parts and Labour Critical Applications Arbitration and Dispute ResolutionDisclaimer and Limitation of Remedy General Provisions How to Obtain Warranty ServicesToshiba America Information SYSTEMS, INC
Related manuals
Manual 62 pages 13.49 Kb