Toshiba 51H85C, 65H85C Adding channels to the TVÕs memory, Programming channels automatically

Adding channels to the TVÕs memory

When you press Channel		or , your TV will stop only on the	Note:
	y	z
channels stored in the TVÕs channel memory.			To tune the TV to a channel not programmed
Follow the steps below and on the next page to program all active			in the channel memory, you must use the

channels into the TVÕs memory.	Channel Number buttons on the remote
	control.

Introduction

Programming channels automatically

Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are stored automatically, you can manually add or erase individual channels (see page 26).

To program channels automatically:

1.Press MENU, and then press x or • until the SET UP menu appears.

2.Press y or z until the TV/CABLE is highlighted, and then press ENTER to display the pull-down menu.

3.Press y or z to highlight either TV or CABLE, depending on which you use. If you use an antenna, highlight TV; if you use cable, highlight CABLE.

TV/VIDEO RECALL POWER

INFO

1 2 3

4 5 6

7 8 9

+10CHRTN

100 0 ENT

Connecting	yourTV
the	control

	SET UP
LANGUAGE	TV
CLOCK SET	CABLE
ANT 1 / 2
TV / CABLE
CH PROGRAM
ADD / ERASE
: SELECT	ENTER : SET

4.Press ENTER.

5.Press z to select CH PROGRAM.

	SET UP
LANGUAGE		ENGLISH
CLOCK SET		0 0 : 0 0
ANT 1 / 2		ANT1
TV / CABLE		CABLE
CH PROGRAM
ADD / ERASE		ADD

			NU				G
			E	FAV			UI
		P	M			PIC	D
	O		FAVORITE					E
T						SI
							ZE
				MENU
				DVDMENU
		ENTER				EXIT			R
N
E
	T			FAV				A
		E
			R				LE
							C
	TV			CH	VOL
	CBL/SAT
	VCR
	DVD
			POP DIRECT CH MUTE			SLEEP
TV/VCR				PAUSE	STOP	PLAY
				FREEZE	SOURCE	SPLIT
		REW		FF	SKIP/SEARCH
CH SCAN				SWAP	POP CH
		REC				LIGHT

MENU

yzx •

ENTER Channel yz

Using	remote
Settingup	yourTV
TVÕs

: MOVE ENTER : START

6.Press ENTER to start channel programming. The TV will automatically cycle through all the TV or Cable channels (depending on which you selected), and store all active channels in the channel memory.

While the TV is cycling through the channels, the message ÒProgramming NowÑPlease WaitÓ appears.

7.When channel programming is complete,the message ÒCompletedÓ appears.

8.Press Channel y or z to view the programmed channels.

Usingthe Features

Appendix

Index

25