Toshiba 51H85C, 65H85C, 57H85C Locking channels, Unlocking programs temporarily, Connecting yourTV

Unlocking programs temporarily

1.If you try to watch a TV program that exceeds the rating limits you set, the TV enters program lock mode. After 4 seconds, the TV automatically starts the auto favorite channel search function (see page 39). You can either unlock the program temporarily (see steps 2-4) or select an unlocked program to watch.

Introduction

THIS PROGRAM

HAS BEEN BLOCKED!

TV–PG L V

EXCEEDS SET L I M I TS

PUSH MUTE TO ENTER PI N

CABLE 9

After 4 seconds

2	3	4	5
6	7	8	9
			X
10	11	12	13

Connecting yourTV

2.To temporarily unlock the program, press MUTE while the message is on the screen.

3.Press the Number buttons (0-9) to enter your 4-digit PIN code.

BLOCK I NG ACT I VE

ENTER P I N CODE

TO TEMPORARI LY UN–BLOCK

– – – –

0 – 9 : TO SELECT ENTER: TO SET

4.Press ENTER.

If the correct code is entered, the program lock mode is released and the normal picture appears.

All locking is disabled until the TV is turned off, and will be enabled when the TV is turned on again.

Locking channels

With the CH LOCK feature, you can lock specific channels. You will not be able to tune locked channels with the Channel y z buttons or Channel Number buttons unless you clear the setting.

You can lock a maximum of nine channels. To lock channels:

1.Make sure the POP is not tuned to a channel you want to lock.

2.From the LOCKS menu, press y or z to highlight CH LOCK, and then press ENTER.

The CH LOCK menu appears, and CH INPUT will be highlighted.

3.Press the Channel Number buttons to enter the channel you want to lock.

			TV/VIDEO RECALL				POWER
					INFO
				1	2			3
				4	5			6			Channel
				7	8			9
											Number
				+10			CHRTN
			100		0			ENT
			NU					G
			E		FAV			UI
		P	M					PIC	D
	O		FAVORITE							E
T								SI
								ZE
					MENU
					DVDMENU						yzx •
E ENTE								EXIT			R
N				R						A
	T				FAV
		E
			R						LE		ENTER
								C
	TV				CH		VOL
	CBL/SAT
	VCR
	DVD
				POP DIRECT CH MUTE				SLEEP
TV/VCR					PAUSE	STOP		PLAY			MUTE
					FREEZE SOURCE			SPLIT
		REW			FF	SKIP/SEARCH
CH SCAN					SWAP		POP CH
		REC						LIGHT

LOCKS menu

	LOCKS
V - CH I P
CH LOCK		OFF
V I DEO LOCK
NEW P I N CODE
: MOVE	ENTER : START

Usingthe	remotecontrol
Settingup	yourTV
UsingtheTVÕs	Features
Appendix

4. Press ENTER.

CH LOCK

CH I NPUT				12
	– – –	– – –	– – –
	– – –	– – –	– – –
	– – –	– – –	– – –

TV CABLE

CLEAR ALL

LOCKS MENU

0–9 : SELECT ENTER : SET

CH LOCK

CH I NPUT			– – –
	12	– – –	– – –
	– – –	– – –	– – –
	– – –	– – –	– – –

TV CABLE

CLEAR ALL

LOCKS MENU

0–9 : SELECT ENTER : SET

Note:

After programming CH LOCK, change the channel before turning off the TV.

Index

5. Repeat steps 3 and 4 for other channels.

43