Getting started
Note:
After the Auto scan, the TV may have scanned identical channels being broadcast from different transmitters. You can verify this by previewing those channels in the Channel List with identical logical numbers and check on their physical channel numbers (- page 30). If you do find channels with the same logical channel numbers but different physical channel numbers, it is recommended that you skip these duplicate channels and keep only one channel with the best signal strength as indicated by the SNR indicator in the
Manual scan - digital only -
If there were any missing channel after Auto Scan, these channels might be found by using Manual Scan described in this section. Also, if you do not live in Australia, you must use Manual Scan to scan those channels in your country.
1From the SCAN menu, press or to select Manual Scan, then press Q.
2Enter password using the Number buttons or press 0000 (which is the default password), then Manual Scan will appear.
Manual Scan
Programming channels automatically
- analog only -
First, use the Auto tuning function to preset all the active channels in your area automatically. Then, arrange the preset channels with the Manual tuning function so that you can tune into only desired channels.
1Press M, then press or to display the SET UP menu.
2Press or to select Auto tuning.
SET UP |
|
| |
|
|
|
|
Language |
| English |
|
Auto tuning | OK | ||
Manual tuning | OK | ||
|
|
|
|
ANT ATT |
| Off |
|
AV connection | OK | ||
Picture position | OK | ||
|
|
|
|
MENU Back EXIT Watch TV |
|
| |
3Press Q to display the Auto tuning menu.
Auto tuning
!Press OK key to start. EXIT for no c hange.
MENU Back EXIT Watch TV
4 Press Q to start the automatic search. |
The search will begin for all available stations. |
Channel No.
Frequency
Bandwidth
Priority
6
1775000 KHz
7MHz
HIGH
Scanning...
Auto tuning
Searching
Pos :2
EXIT Stop
Start Scan
Signal Level | 100% |
|
|
Quality70%
SNR: 20dB
The slide bar will move along the line as the search progresses.
If you make a mistake, simply repeat steps
Back Select Function |
| Watch TV |
3Press or to select the item you wish to adjust. For Australia, to adjust Frequency, you may refer to the latest channel table from local dealer. And the
Bandwidth is 7MHz and Priority should be set to HIGH. Then press or to select Start Scan and press Q to start scanning.
4If scanning was successful, Get Channel Success appeared for 2 seconds. Repeat to scan other channels as necessary.
5If scanning was unsuccessful, Timeout Error appeared. At this point you can rescan the signal or refer to the Signal Level bar and Quality for aligning the direction of the antenna to get the signal. Refer to your antenna installer if problem persists.
Notes:
•Signal level refers to the input Radio Frequency (RF) signal strength as perceived by the TV. Note that too strong signal may cause erroneous readings. If you use an antenna booster and find that you still get a low signal level, your booster gain may be set too high. In this case, adjust the gain accordingly. You may also see the No Signal on the screen when the signal level is low.
•Quality refers to the quality of the received digital signal. A high value of quality means that there are few errors in the signal. In the same way, a low value of quality implies that there are a large number of errors in the signal, which may cause distortions in video and audio.
5When the automatic search is completed, the TV will automatically return to the first program position.
6Press or to view the programmed position.
Note:
When you preset the program channel which sound of broadcast transmission system adopts “M” system, the sound system may not be tuned correctly if the radio waves transmit badly. At that time, preset the channel by Manual tuning.
14