Toshiba 46XV540U, 52XV540U, 42XV540U manual Care, Service

Page 4

23)Always place the back of the television at least four (4) inches away from any vertical surface (such as a wall) to allow proper ventilation.

24)Never allow anything to rest on or roll over the power cord, and never place the TV where the power cord is subject to wear or abuse.

25)Never overload wall outlets and extension cords.

26)Always operate this equipment from a 120 VAC, 60 Hz power source only.

27)Always make sure the antenna system is properly grounded to provide adequate protection against voltage surges and built-up static charges (see Section 810 of the National Electric Code).

31)

WARNING:

RISK OF ELECTRIC SHOCK!

Never spill liquids or push objects of any kind into the TV cabinet slots.

32)

While it is thundering, do not touch the connecting cables

 

or apparatus.

 

 

33)

For added protection of your TV from lightning and power

 

surges, always unplug the power cord and disconnect the

 

antenna from the TV if you leave the TV unattended or

 

unused for long periods of time.

 

 

34)

During normal use, the TV may make occasional snapping

 

or popping sounds. This is normal, especially when the

 

unit is being turned on or off. If these sounds become

 

frequent or continuous, unplug the power cord and contact

Ground clamp

Electric service equipment

Ground clamps

Antenna lead-in wire

Antenna discharge unit (NEC Section 810-20)

Grounding conductors (NEC Section 810-21)

Power service grounding

electrode system (NEC Art 250 Part-H)

a Toshiba Authorized Service Center.

35)

WARNING: RISK OF

 

SERIOUS PERSONAL

 

INJURY OR EQUIPMENT

 

DAMAGE!

Never strike the screen with a sharp or heavy object.

36) • The LCD screen of this product can be damaged by

ultraviolet radiation from the sun. When selecting a

location for the television, avoid locations where the

28)

DANGER: RISK OF SERIOUS

PERSONAL INJURY OR DEATH!

Use extreme care to make sure you are never in a position where your body (or any item you are in contact with, such as a ladder or screwdriver) can accidentally touch overhead power lines. Never locate the antenna near overhead power lines or other electrical circuits.

Never attempt to install any of the following during lightning activity: a) an antenna system; or b) cables, wires, or any home theater component connected to an antenna or phone system.

Care

For better performance and safer operation of your TOSHIBA TV, follow these recommendations and precautions:

29)If you use the TV in a room whose temperature is 32 ºF (0 ºC) or below, the picture brightness may vary until the LCD warms up. This is not a sign of malfunction.

30)Always unplug the TV before

cleaning. Gently wipe the display panel surface (the TV screen) using a dry, soft cloth only (cotton, flannel, etc.). A hard cloth may damage the surface of the panel. Avoid

contact with alcohol, thinner, benzene, acidic or alkaline solvent cleaners, abrasive cleaners, or chemical cloths, which may damage the surface. Never spray volatile compounds such as insecticide on the cabinet. Such products may damage or discolor the cabinet.

In addition, gently wipe the luster finishing portion of your TV with the enclosed cleaning cloth after removing any dirt or dust from the surface. Harsh rubbing or use of a dirty cleaning cloth or stiff cloth will scratch your TV.

screen may be exposed to direct sunlight, such as in

front of a window.

• Never touch, press, or place anything on the LCD

screen. These actions will damage the LCD screen. If

you need to clean the LCD screen, follow the

instructions in item 30 on this page.

Service

37)

WARNING:

RISK OF ELECTRIC SHOCK!

Never attempt to service the TV yourself. Opening and removing the covers may expose you to dangerous voltage or other hazards. Failure to follow this WARNING may result in death or serious injury. Refer all servicing not specified in this manual to a Toshiba Authorized Service Center.

38)If you have the TV serviced:

Ask the service technician to use only replacement parts specified by the manufacturer.

Upon completion of service, ask the service technician to perform routine safety checks to determine that the TV is in safe operating condition.

39)The cold cathode fluorescent lamp in the LCD panel contains a small amount of mercury.

When the TV reaches the end of its useful life, dispose of the used TV by the approved method for your area, or ask a qualified service technician to properly dispose of the TV.

Note: The lamp(s) inside this product contain mercury. Disposal may be regulated due to environmental considerations. For disposal or

recycling information, contact your local authorities or the Electronics Industries Alliance (www.eiae.org).

4

Image 4
Contents 42XV540U 46XV540U 52XV540U Safety Precautions IssueTune Into Safety Dear CustomerImportant Safety Instructions Installation, Care, and ServiceAdditional Safety Precautions InstallationService CareTo Display your LCD TV using a Wall Bracket Choosing a location for your LCD TVTo Display your LCD TV on the included Pedestal Stand Removing the Pedestal StandImportant notes about your LCD TV PartTrademark Information Contents Troubleshooting For details on using the TV’s features, see Chapters 6 Features of your new TVIntroduction Effective range TV front and side panel controls and connectionsGreen and Yellow LEDs TV back panel connections Colorstream HD1 and Colorstream HD2Overview of cable types Connecting your TVAbout the connection illustrations To view the antenna or Cable signal You will needTo view basic and premium Cable channels To view the VCRTo view antenna or Cable channels To view the DVD playerTo view the VCR or view and record antenna channels To record a TV program while watching a DVDTo control the devices To connect the IR blaster cableIf you cannot locate the device’s infrared sensor Connecting an Hdmi or DVI device to the Hdmi input To connect an Hdmi device, you will needTo view the Hdmi device video To connect a DVI device, you will needBefore controlling the devices REGZA-LINK connectionHdmi cables To control the audio Connecting an audio systemStandard audio cables Connecting a personal computer PC SignalTo connect a PC to the PC in terminal on the TV To connect a PC to the Hdmi terminal on the TVUsing the remote control Preparing the remote control for useInstalling the remote control batteries If you have a Toshiba deviceTV, CABLE/SAT, HD DVD, DVD, and VCR/PVR. Press Mode Select sets the five remote control device modesTV until the keypad blinks 3 times to control the TV Remote Control functional key chart PVR= key does not send a signal in that remote control mode Using the remote control to operate your other devices Device code setupMode Select Default device mode control before programming Mode Select Device mode control after programmingUsing the volume lock feature Operational feature resetTo unlock the remote control’s volume keys To reset the remote controlCable boxes TVsSatellite receivers DVDs 3D LABDVD/VCR Combo HD DVDsVCRs KEC STS PVRs Cable/PVR ComboDBS/PVR Combo Audio AmpAudio Amp/Tuners SAESetup/Installation menu layout Menu layout and navigationMain menu layout Thinc menuNavigating the menu system ApplicationsSetting the Demo Mode Setting up your TVSelecting the menu language Configuring the input source for the ANT/CABLE terminal To configure the ANT/CABLE input sourceProgramming channels automatically To program channels automaticallySetting the Auto Input feature Manually adding and deleting channels in the channel memoryLabeling channels Viewing the digital signal meter Setting the Hdmi audio modeSetting the time zone Selecting the Power-On Mode Selecting the Demo ModeReset Factory Defaults Viewing the system statusLabeling the video input sources Using the TV’s featuresTo label the video input sources Tuning channels using Channel Browser Tuning channelsFavorites Browser Elements of the Channel Browser Setting the Channel Tuning Mode Tuning to the next programmed channelTuning to a specific channel programmed or unprogrammed Adding and clearing channels and inputs in the History ListSwitching between two channels using Channel Return Switching between two channels using SurfLockTo select the picture size using the remote control To select the picture size using the menusPicture Size Natural TheaterWide For 43 format programsTheaterWide For letter box programs TheaterWide For letter box programs with subtitlesUsing the auto aspect ratio feature To set the scroll settingsTo turn on the auto aspect ratio feature To turn off the auto aspect ratio featureUsing the Freeze feature Adjusting the pictureSelecting the picture mode Adjusting the picture qualityUsing the closed caption mode Using the TheaterLock featureBase closed captions Adjusting the audio Digital CC SettingsUsing the Closed Caption button on the remote control CC SelectorAdjusting the audio quality Using the digital audio selectorSelecting stereo/SAP broadcasts Using the Locks menu Using the StableSound featureUsing the Dolby Digital Dynamic Range Control feature Entering the PIN codePress b to highlight Enable Rating Blocking If you cannot remember your PIN codeChanging your PIN code Blocking TV programs and movies by rating V-ChipTo download the additional rating system if available Using the input lock feature Using the GameTimerBlocking channels Unlocking programs temporarilyUsing the PC settings feature Using the control panel lock featureTo adjust the PC settings To lock the control panelSetting the PC Audio Setting the sleep timerUsing REGZA-LINK REGZA-LINK playback device HD DVD player, etc. controlVolume and Mute controls of Audio Receiver REGZA-LINK input source selectionOther REGZA-LINK functions REGZA-LINK Player Control menu functionsTo set the REGZA-LINK Setup Using the Hdmi settings featureTo set the Hdmi Settings Understanding the auto power off feature Understanding the last mode memory featureTo display TV status information using Recall To display TV status information using InfoUsing the TV’s advanced features Using the advanced picture settings featuresUsing dynamic contrast Using the static gamma featureUsing the Film Stabilization feature Using the ClearFrame featureUsing CableClear digital noise reduction Using the ColorMaster feature Using Mpeg noise reductionUsing Color Palette Adjustment Using the advanced audio settings features Using x.v.Color Selection featureUsing the Game Mode feature Using the surround sound featuresTroubleshooting General troubleshootingRemote control problems Channel tuning problemsClosed caption problems Rating blocking V-Chip problemsLED indications Specifications AppendixFormat Resolution Frequency Pixel Clock Frequency Acceptable signal formats for PC in and Hdmi terminals1280 60.020Hz 63.981kHz 108.000MHz Limited United States Warranty For LCD Televisions 26 and LargerLimited Canadian Warranty For Toshiba Brand Flat Panel TelevisionsDisclaimer and Limitation of Remedy Index Freeze08-03