CHANNEL PRESET (continued)
Notes
•When “SKIP” is set to “ON” for the selected position number, a “ * ” mark appears to the left of the position number.
12
The position number will then be skipped when you select the position with CH s/t.
•If you want to restore a skipped position number, select it using the
Manual fine tuning (MFT)
The adjustments below are not necessary under normal conditions. However, under some reception conditions, fine tuning may be necessary to improve the picture quality. In such cases, adjust the manual fine tuning (MFT).
1Select the position number where the channel you want to
2Press MENU and then ; 
TUNING” icon.
3Press CH s/t to select “MFT”. Press ;
TUNING |
|
|
MFT |
|
|
AFT |
| ON |
ASM |
|
|
SEARCH |
| P002 |
POSITION |
| |
MEMORY |
|
|
SELECT / | ADJUST | BACK MENU |
Auto fine tuning (AFT)
If the signal frequency is unstable due to environmental conditions, use auto fine tuning.
1Select the position number where the channel you want to
Note
When the position is set to “AFT OFF” status, the “ R ” mark appears to the left of the position number.
25
When the channel is set to “AFT ON” status, the position number is displayed without the “R” mark.
2Press MENU then ; 
TUNING” icon.
3Press CH s/t to select “AFT”. Press
TUNING |
|
|
MFT |
| OFF |
AFT |
| |
ASM |
|
|
SEARCH |
| P002 |
POSITION |
| |
MEMORY |
|
|
SELECT / | ADJUST | BACK MENU |
Notes
•When you operate MFT, AFT is switched “OFF” automatically. If you switch on AFT after fine tuning with MFT, MFT may be canceled.
•AFT may be set independently for each position.
14
14 | 23/9/05, 9:28 AM |