Preparing the remote control for use

Setting up your TV

Using the remote control

With the remote control, you can operate your TV, most cable TV converters/satellite receivers, VCRs, and DVD players together, even if they are different brands. If you will be using your TV with a Toshiba satellite receiver, VCR, or DVD player, your remote control is already programmed and ready to use. If you own different brands of cable TV converters/satellite receivers, VCRs, and/or DVD players, you must first program your remote control. (See “Programming the

remote control to operate your other devices," on page 18.)

Installing the remote control batteries

To install the batteries:

1. Open the battery cover on the back of the remote control.

2.Install two “AAA” size batteries. Match the + and – signs on the batteries to the signs on the battery compartment.

3. Close the battery cover on the remote control until the lock snaps.

Note:

The TV remote control may not operate your VCR, DVD player, or cable TV converter. Refer to the owner's manual supplied with your other devices to see which features may be available. Additionally, the remote control for this TV may not support certain features available on the original remote controls for your other devices, in which case it is suggested that you use the original remote control for the applicable device.

Caution:

• Never throw batteries into a fire.

Notes:

•Be sure to use AAA size batteries.

•Dispose of batteries in a designated disposal area.

•Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with applicable laws and regulations.

•If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries with new ones.

•When necessary to replace batteries in the remote control, always replace both batteries with new ones. Never mix battery types or use new and used batteries in combination.

•Always remove batteries from remote control if they are dead or if the remote control is not to be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment.

Introduction

Connecting your TV

Setting up your TV

Using the remote control to operate your other devices

To control a cable TV

Power

To control a VCR:

converter/satellite

receiver:

Program the remote control to recognize the brand of your cable TV converter/satellite receiver (see “Programming the remote control to operate your other devices” on page 18.) The buttons shown at right will control the cable TV converter/

Input (TV)

Mute (TV)

Channel

Numbers

CH RTN (Channel Return)

Channel 3 4

CBL/SAT Volume +/- (TV)

Pic Size (TV)

INPUT DISPLAY

Program the remote control to recognize the brand of your VCR (see “Programming the remote control to operate your other devices” on page 18.) The buttons shown at right will then control the VCR.

Press “VCR” first.

INPUT DISPLAY

Input (TV)

Power

Channel

Numbers

CH RTN (Channel Return)

VCR Channel 3 4 Volume +/- (TV)

Pic Size (TV)

satellite receiver. Press “CBL/SAT” first.

TV/VCR

VCR controls