Toshiba 20HL85 appendix Precautions, Screw

Page 6

Important notes about your LCD TV

Introduction

The following symptoms are technical limitations of LCD Display technology and are not an indication of malfunction; therefore, Toshiba is not responsible for perceived defects resulting from these symptoms.

1)An afterimage (ghost) may appear on the screen if a fixed, non-moving image is displayed for a long period of time. The afterimage is not permanent and will disappear in a short period of time.

2)The LCD panel contained in this TV is manufactured using an extremely high level of precision technology; however, there may be an occasional pixel (dot of light) that does not operate properly (does not light, remains constantly lit, etc.). This is a structural property of LCD technology, is not a sign of malfunction, and is not covered under your warranty. Such pixels are not visible when the picture is viewed from a normal viewing distance.

Note: Interactive video games that involve shooting a “gun” type of joystick at an on-screen target may not work with this TV.

Precautions

Notes on handling

Do not subject the LCD panel to physical shock, such as dropping it. It may cause unit damage and malfunction.

Retain the original shipping carton and packing materials. For maximum protection when shipping, repack the unit as it was originally packed at the factory.

Do not use volatile liquids, such as insecticide, near the unit. Do not leave rubber or plastic products in contact with the unit for prolonged periods of time. Doing so will leave marks on the finish.

The top and rear panels of the unit may become warm after a long period of use. This is not a malfunction.

When the unit is not in use, turn off the power.

If you do not use the unit for a long period, the unit may not function properly in the future. Turn on and use the unit occasionally.

Notes on locating the unit

When you place this unit near a TV, radio, or VCR, the playback picture may become poor and the sound may be distorted. In this case, place the unit away from the TV, radio, or VCR.

To avoid damage to this product, never place or store the TV in direct sunlight; hot, humid areas; or areas subject to excessive dust or vibration.

Always place the TV on the floor or a sturdy, level stable surface that can support the weight of the unit. Use a sturdy tie between the TV's rear hooks and the rear wall, pillar, etc., or screw the TV to the stand using the TV’s rear screw hole or a safety band (see illustration).

Notes on cleaning

Clean only with a soft, dry, lint-free cloth.

Notes on LCD

The color LCD is manufactured using extremely high precision technology, but even so may include certain pixels that do not operate properly (that do not light, that remain lit constantly, etc.). We do our best to keep the number of these defective pixels to a minimum, but please understand that they cannot be completely eliminated even with the most advanced manufacturing technologies available today.

The fluorescent tube which illuminates the panel from the inside will deteriorate with use. When the LCD becomes dim, flickers, or does not illuminate, contact your dealer for replacement.

The brightness of the LCD monitor differs slightly depending on the viewing angles. Adjust the angle to obtain the best viewing. (The recommended angle is 90 degrees to the monitor.)

Screw

Screw holes

Tie

Wall

Hooks

TV Stand

Screw

 

 

Safety Band

6

J3U70101C(E)P02-10

6

15/06/2005, 4:10 PM

Image 6
Contents TV’s Features Your TVIntroduction Dear CustomerFederal Communications Commission FCC FCC compliance informationAppendix FCC Declaration of Conformity Compliance Statement PartVentilation Heat Introduction Connecting your TV Setting up your TVUsing the TV’s Features Appendix LCDPrecautions ScrewSetting up your TV Connecting your TVPower source Using the TV’s featuresExploring your new TV Connecting a VCR Selecting a location for the TVStereo VCR Connecting a cable converter box or antenna Option 1 For Subscribers to Basic Cable TV ServiceOption 2 For Subscribers to Scrambled Cable TV Service Connecting a DVD player/satellite receiver and a VCR DVD player with Component video From DTV Antenna Connecting a camcorder To connect an Hdmi device, you will need Connecting an Hdmi or a DVI device to the Hdmi input’s Features To connect a DVI device, you will needTo use AC power Connecting a PC Personal ComputerPower connection Monitor Display modesPreparing the remote control for use Installing the remote control batteriesUsing the remote control to operate your other devices Programming the remote control to operate your other devices To control a DVD playerSetting up Your TV Using the TV’s Features AppendixSetting Up your TVLearning about the remote control To select a language Starting setupChanging the on-screen display language PressAdding and erasing channels manually Adding channels to the TV’s memoryProgramming channels automatically Changing channelsAdjusting the channel settings Switching between two channelsProgramming your favorite channels To select your password and access the Locks menu Using the Locks menuSelecting a password To change your passwordUsing the V-Chip parental control feature Locking channels Setting the GameTimerTM Using the panel lock featureLabeling channels To create channel labelsTo erase channel labels Labeling the video input sources Setting the clockSelecting the video input source To label the video input sourcesSetting the on timer Setting up your TV Using the TV’s FeaturesTo cancel the on timer TheaterWide picture size for 43 format programs Selecting the picture sizeNatural picture size Full picture size for 169 source programsTo set the Cinema Mode to Film Selecting the cinema modeUsing the Aspect feature To set the Cinema Mode to Video offSetting the sleep timer Using the closed caption featureAdjusting the picture quality Adjusting the pictureSelecting the picture mode Connecting your TV SettingResetting your picture adjustments Using the CableClear featureSelecting the color temperature TV’sMuting the sound Adjusting the soundAdjusting the sound quality Selecting stereo/SAP broadcastsResetting your audio adjustments Using the StableSound featureUsing the WOW surround sound feature Understanding the Power Return feature Adjusting the back lighting featureAuto power off Selecting the Hdmi audio input sourcePicture/Audio adjustments in the PC mode Resetting your picture/audio adjustments in the PC modePicture menu Troubleshooting Symptom SolutionSpecifications VHF UHFLimited United States Warranty Limited Canada Warranty TV’s Features Appendix MemoMemo Memo National Service Division